Bedienungsanleitung Indesit DE73 (Seite 13 von 16) (Englisch)

46850

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Cleaning and Special Maintenance

Filter Assembly

For best performance and results, the filter assembly must

be cleaned .

The filter efficiently removes food particles from the wash

water, allowing it

to be recirculated

during the cycle.

For this reason, it

is a good idea to

remove the

larger food

particles trapped

in the filter after

each wash cycle

by rinsing the

"A" semi-circular filter and cup under running water. To

remove the filter assembly, pull on the cup handle in the

upward direction. The entire filter assembly (made up of

the "A" semicircular filter and the "B" fine filter) should be

cleaned at least once a month.

To clean the filter and the fine filter, use a cleaning brush.

Then, reassemble the filter parts as shown in the figures

below and reinsert the entire assembly in the dishwasher,

positioning in its seat and

pressing downward.

The dishwasher must

never be used without the

filters. Improper

replacement of the filters

may reduce the perfor-

mance level of the

appliance and damage

dishes and utensils.

Cleaning the Sprayer

Arms

It may happen that food particle become encrusted on the

sprayer arms and block the holes (see "Close up view

(interior)", letters F-I). Check the sprayer arms periodically

and clean them when needed.

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter (see figure 2 under

"Installation") located on the outlet of the water supply tap.

After turning off the water tap, unscrew the end of the water

supply hose, remove the filter and clean it carefully under

running water. Then, return the filter to its place and tighten

the water supply hose back into position.

Troubleshooting

It may occur that the dishwasher does not function or does

not function properly. Before calling for assistance, let us

see what can be done first.

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Load Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient

pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

The Dishes Are Not Clean

Have you put the right amount of detergent into the

dispenser?

Is the wash cycle suitable for the dishes you have placed

inside the appliance?

Are the filter and microfilter clean?

Can the sprayer arms turn freely?

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the lid to the salt container is closed properly;

- the rinse aid dosage is correct.

Error messages

The dishwasher is equipped with a safety system which is

able to detect any operating anomalies. These anomalies

are signalled by some messages flashing on the counter. When

H2O is flashing, you should cancel the wash cycle as described

in the paragraph entitled “Cancelling or modifying a wash

cycle in progress”, then check whether there is any water in

the mains supply and that the water tap has been turned on.

Restart the appliance following the instructions provided and

if the message persists, then call for Technical Assistance. In

all other cases, remember the message which is flashing on

the counter, turn the appliance off and call for technical

assistance, stating which message was flashing.

If, despite all these checks, the dishwasher still does not

function and/or the problem persists, contact the nearest

authorised service centre and provide them with the

following information:

- the nature of the problem;

- the model type number (Mod. ...) and the serial number

(S/N ....), which are indicated on the plate located on the

side of the inner part of the door.

Never call on unauthorised technicians and refuse to

allow parts to be installed that are not original spare

parts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit DE73 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info