Bedienungsanleitung Indesit DIF 66B1 (Seite 14 von 44) (Englisch, Holländisch, Französisch)

575202

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Troubleshooting

Whenevertheappliancefailstowork,checkforasolutionfromthefollowinglistbeforecallingforAssistance.

* Only available in selected models.

Problem: Possible causes / Solutions:

The dishwasher does not start or

cannot be controlled.

• Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately

one minute and reset the program.

• The appliance has not been plugged in properly.

• The dishwasher door has not been shut properly.

The door won’t close. • The lock was released. Strongly push the door until a “clacking” noise is heard.

No water drains out from the

dishwasher.

• The dishwasher cycle has not yet nished.

• The water inlet hose is bent (see Installation).

• The drain duct is blocked.

• The lter is clogged up with food residues.

The dishwasher makes excessive

noise.

• The dishes are rattling against each other or against the sprayer arms.

• Excessive foam presence: the detergent has not been measured out correctly or it is not

suitable for use in dishwashers. (see Start-up and use).

The dishes and glasses are covered

in a white lm or limescale deposits.

• The level of the rened salt is low or the dosage setting is not suited to the hardness of the

water (see Rinse aid and salt).

• The lid on the salt dispenser is not closed properly.

• The rinse aid has been used up or the dosage is too low.

The dishes and glasses are streaked

or have a bluish tinge.

• The rinse aid dosage is too high.

The crockery has not been dried

properly.

• A wash cycle without a drying programme has been selected.

• The rinse aid has been used up or the dosage is too low (see Rinse aid and salt).

• The rinse aid dispenser setting is not high enough.

• The crockery is made from non-stick material or plastic.

The dishes are not clean.

• The racks are overloaded (see Loading the racks).

• The crockery has not been arranged well.

• The sprayer arms cannot move freely.

• The wash cycle is too gentle (see Wash cycles).

• Excessive foam presence: the detergent has not been measured out correctly or it is not

suitable for use in dishwashers. (see Start-up and use).

• The lid on the rinse aid compartment has not been shut correctly.

• The lter is dirty or blocked (see Care and maintenance).

• The rened salt level is low (see Rinse aid and salt).

The dishwasher does not take

any water in - Tap shut-off

alarm.

(beeps are emitted

* and all the cycle

indicator lights ash.

The ON/OFF indicator light ashes

rapidly and the 2nd and 3rd wash cycle

indicator lights ash.

• There is no water in the mains supply.

• The water inlet hose is bent (see Installation.)

• Turn on the tap and the appliance will start after a few minutes.

• The appliance lock has been activated because no action was taken when

the beeps sounded.

• Switch off the machine using the ON/OFF button, turn on the tap and switch

the machine back on after a few seconds by pressing the same button. Re-

program the appliance and restart the wash cycle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit DIF 66B1 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info