Bedienungsanleitung Indesit FIE 56 (Seite 21 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

510537

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

 The stainless-steel or enamel-coated external

parts as well as the rubber seals may be cleaned

using a sponge that has been soaked in

lukewarm water and neutral soap. If these stains

are difficult to remove, use only specialised

products. After cleaning, rinse and dry

thoroughly. Do not use abrasive powders or

corrosive substances.

 Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft cloth.

Do not use abrasive products.

 All accessories - with the exception of the sliding

racks - can be washed like everyday crockery,

and are even dishwasher safe.

 Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

To clean more thoroughly, you can remove the

oven door.

1. Open the oven door fully (see diagram)

2. Lift up and turn the small levers located on the

two hinges (see diagram)

3. Grip the door on the two

external sides and close it

approximately half way. Then

pull the door towards you

lifting it out of its seat (see

diagram).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the

oven light bulb:

1. Remove the

glass cover of the

lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

Wattage 25 W,

cap E 14.

3. Replace the glass cover (see diagram).

Assembling the sliding rack kit

To assemble the sliding racks:

1. Remove the two

frames, lifting them

away from the spacers

A (see figure).

2. Choose which shelf

to use with the sliding

rack. Paying attention

to the direction in which

the sliding rack is to be

extracted, position joint

B and then joint C on

the frame.

3. Secure the two

frames with the guide

rails using the holes

provided on the oven

walls (see diagram).

The holes for the left

frame are situated at

the top, while the holes

for the right frame are

at the bottom.

4. Finally, fit the frames on the spacers A.

 Do not place the sliding racks in position 5.

Maintenance and care

Left

guide rail

Right guide

rail

Direction

of extraction

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit FIE 56 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info