Bedienungsanleitung Indesit IDE1000 (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

46872

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Start-up and use

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button: the display will light up.

3. Measure out the detergent (

see below

4. Load the racks (see Loading the racks) and shut the door.

5. Select the programme by turning the WASH CYCLE

SELECT knob in a clockwise direction: align the notch on the

knob with the number or symbol representing the desired

wash cycle.

6. Select the wash options (

see below

7. Start the cycle by pressing the START/RESET button: the

machine will emit a confirmation beep. The WASH CYCLE

PHASE indicator lights display the status of the cycle: Pre-

wash, Wash, Rinse, or Drying.

8. At the end of the cycle three short beeps will sound and

END will appear on the display. Switch off the appliance by

pressing the ON/OFF button, shut off the water tap and

unplug the appliance from the electricity socket.

9. Open the door and wait for a few minutes before removing

the crockery, in order to avoid burns. Unload the racks,

beginning with the lower level.

Demo*

If dON appears on the display, this means that the appliance

is in demonstration mode. To deactivate it, press the START/

RESET and ON/OFF buttons simultaneously: dOF should

appear on the display.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: press and hold the START/RESET button for 4

seconds. After one long beep and three short beeps, the

WASH CYCLE PHASE indicator light will switch off. Select the

new cycle and switch the machine back on by pressing the

START/RESET button.

Adding extra crockery

Press the ON/OFF button and open the door, taking care to

avoid the escaping steam, and place the crockery inside the

dishwasher. Press the ON/OFF button again: the cycle starts

from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct amount of

detergent being used, as recommended by the manufacturer.

Exceeding the recommended amount does not result in a

more effective wash and pollutes the environment.

Only use detergent which has beenOnly use detergent which has been

Only use detergent which has been

specifically designed for dishwashers.specifically designed for dishwashers.

specifically designed for dishwashers.

DO NOT USE washing up liquid.DO NOT USE washing up liquid.

DO NOT USE washing up liquid.

To obtain the best results from each washing and drying

cycle, powder detergent, rinse aid liquid and salt should be

used.

compartment Acompartment A

compartment A: Washing detergent

compartment Bcompartment B

compartment B: Pre-wash detergent

1. Open cover C by pressing

button D.

2. Pour in the detergent after

consulting the

Wash cycle table

• for powder detergent use

compartments A and B

• for tablets, use compartment A

and the bottom of the appliance, i.e.

when the cycle requires 1 tablet,

place it in compartment A and close

the cover; when it requires 2, place

the second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle for a period of

time between 1 and 24 hours.

1. Press the DELAYED START button: every time the button is

pressed, the time selected appears on the display and the

delayed start indicator light illuminates.

2. Select the wash cycle and press the START/RESET button:

after the beep sounds, the timer begins counting down.

3.Once this time is up, the indicator light switches off and the

wash cycle begins.

To adjust the delay time and select a lower period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the wash cycle begins and the WASH

CYCLE PHASE indicator light corresponding to the start of the

cycle in progress illuminates.

Half load using the upper rack*

If there are not many dishes to be washed, a half load cycle

may be used in order to save water, electricity and detergent.

Before selecting the wash cycle press the HALF LOAD button

repeatedly: the indicator light will illuminate and the wash cycle

will take place only in the upper rack.

Remember to load the upper rack only, and to reduce the

amount of detergent accordingly.

 It is better to use powder detergent in this case.

Extra drying*

To make sure that the crockery is completely dry at the end of

the cycle, press the EXTRA DRYING button before selecting

the wash cycle. A prolonged beep will sound to indicate that

this option has been selected and a short beep will sound to

indicate when it has been deselected.

If the Extra drying option is selected, the wash cycles will

last longer.

Indesit IDE1000 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Indesit IDE1000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info