Bedienungsanleitung Indesit idl 75 eu 2 (Seite 23 von 76) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

127055

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Installation

Positioning the appliance

Place your dishwasher where you want to install it. The

appliance can even be placed so that its sides or back panel

are side by side with furniture or up against the wall. The

dishwasher is provided with water supply and drain hoses,

which can be directed towards the left or right to facilitate

appropriate installation.

Levelling

Once the appliance is positioned, adjust the feet by screwing

them in or out depending on how high you want it and level

it so that it is horizontal; however it must not be tilted by

more than 2° under any circumstances.

If the appliance is level, this will help ensure its correct

operation.

This dishwasher model can be built under a single worktop

(please read the relevant instruction sheet).

Cold water connection.

This electric household appliance should be connected to

the water mains using the cold water supply hose provided

with the appliance only. Do not use a different hose. In the

event of replacements, use original spare parts only.

Connect the cold water supply hose to a 3/4 gas threaded

connection, taking care to screw it tightly onto the tap.

If the water hoses are new or have been out of use for an

extended period of time, let the water run to make sure it is

clear and free of impurities before making the connection.

If this precaution is not taken, the water inlet could get

blocked, causing damage to your dishwasher.

Hot water connection

Your dishwasher can be supplied with hot water from the

mains supply (if you have a central heating system with

radiators) at a temperature of no more than 60°C.

In this case, the wash cycle time will be about 15 minutes

shorter and the wash will be slightly less effective.

The connection must be made to the hot water supply

following the same procedures as those indicated for the

cold water connection.

Anti-flooding protection

Your dishwasher is provided with a special system which

blocks the water supply in the event of leaks inside the

appliance. It is further equipped with a water inlet hose that

can withstand extremely high pressures and that turns red

in the event of breakage. Safety in the event of flooding is

ensured by the second clear hose that contains the former.

It is vital that you check it on a regular basis: if you see it has

turned red, then you know you have to replace it as soon as

possible. Call for an authorised technical engineer to come

and replace it.

Drain hose connection

Fit the drain pipe into a drain line with a minimum diameter

of 4 cm or place it over the

sink. Avoid restricting or

bending it. Use the special

plastic elbow provided (see fi-

gure) to position it in the best

possible way. The part of the

pipe marked with the letter A

should be between 40 and

100 cm above the ground.

The pipe should not be

immersed in water.

Warning: the special plastic elbow should be fastened firmly

onto the wall to prevent the drain hose from moving and

allowing water to spill outside the drain.

Electrical connection

Plug the appliance into a socket provided with an efficient

earth connection (the system’s earthing is a guarantee of

safety provided for by law), after having checked that the

mains voltage and frequency values correspond to those

stated on the rating plate located on the stainless steel inner

door of the appliance and that the electrical system to which

the dishwasher is connected is sized for the maximum current

indicated on said rating plate. If the power socket to which

the appliance is connected is not compatible with the plug,

replace it with a suitable plug rather than using adapters or

multiple plugs as these could cause overheating or burns.

If the electricity supply wire is damaged, we recommend

you contact authorised Technical Assistance service centres

exclusively for a replacement.

Caution: the dishwasher plug must be accessible so that

maintenance can be done safely.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit idl 75 eu 2 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info