Bedienungsanleitung Indesit IDTM (Seite 7 von 12) (Englisch)

24011

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button: the indicator light will illuminate.

3. Open the door and pour in a suitable amount of detergent

(see below).

4. Load the racks (see Loading the racks) and shut the door.

5. Select the wash cycle end time by turning the SELECTOR

knob between:

•

30 min, 60 min, 90 min, 3h*,6h*,9h* 30 min, 60 min, 90 min, 3h*,6h*,9h*

30 min, 60 min, 90 min, 3h*,6h*,9h*

(see delayed start

section)

, setting the type of wash required based on the

crockery and how soiled it is

(see table of wash cycles).

•

Auto4you wash cycle: Auto4you wash cycle:

Auto4you wash cycle:helps to achieve the best washing

and drying results in a short space of time

(see table of wash

cycles).

6. Select the wash options

(see below).

7. Start the cycle by pressing the START/RESET button: the

machine will emit a confirmation beep. the WASH CYCLE IN

PROGRESS indicator light will illuminate.

8. During the cycle the REMAINING TIME indicator lights

illuminate to show:

o 20 minutes from the end of the wash cycle

o 10 minutes from the end of the wash cycle

9. At the end of the cycle three short beeps will sound and the

WASH CYCLE COMPLETE indicator light will flash.

10. Switch off the appliance by pressing the ON/OFF button,

shut off the water tap and unplug the appliance from the

electricity socket.

11. Open the door and wait for a few minutes before removing

the crockery, in order to avoid burns. Unload the racks,

beginning with the lower level.

Modifying the duration of a wash cycle already in

progress

If the wrong programme was chosen originally, it may be

changed within one minute from when the WASH CYCLE IN

PROGRESS indicator light illuminates: Press and hold the

START/RESET button for 4 seconds; you will hear one long

beep followed by three short ones. Restart the machine by

pressing the START/RESET button.

Adding extra crockery

Press the ON/OFF button and open the door, taking care to

avoid the escaping steam, and place the crockery inside the

dishwasher. Press the ON/OFF button again: the cycle starts

from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct amount of

detergent being used, as recommended by the manufacturer.

Exceeding the recommended amount does not result in a

more effective wash and pollutes the environment.

compartment Acompartment A

compartment A: Washing

detergent

compartment Bcompartment B

compartment B: Pre-wash

detergent

1. Open cover C by pressing

button D.

2. Pour in the detergent after

consulting the

Wash cycle

table

• for powder detergent use

compartments A and B

• for tablets, use compartment A and the bottom of the

appliance, i.e. when the cycle requires 1 tablet, place it in

compartment A and close the cover; when it requires 2, place

the second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

This dishwasher gives the user complete control over the

wash cycle timing. The 3h, 6h and 9h cycles enable the

dishwasher to achieve its best performance, at the exact time

required, by using the AUTO4YOU programme.

It is important to remember that:

• if the 3h cycle has been selected the dishwasher will wail for

30 minutes and then wash for the remaining 150 minutes

• if the 6h cycle has been selected the dishwasher will wail for

3 hours and 30 minutes and then wash for the remaining 150

minutes

• if the 9h cycle has been selected the dishwasher will wail for

6 hours and 30 minutes and then wash for the remaining 150

minutes

To cancel or change the cycle, press the START/RESET button

and after the beeps have been emitted reselect a new cycle.

Restart the cycle using the START/RESET button.

3in1 button*

When using multi-use tablets (2-in-1, 3-in-1, 4-in-1), press the

3in1 button. The overall duration of the programme increases

by approximately 10 minutes when this function is used.

! This option is incompatible with the 30-minute cycle.

Start-up and use

* Only available in selected models.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit IDTM Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Indesit IDTM

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info