Bedienungsanleitung Indesit IDVA 835 (Seite 14 von 80) (Englisch, Holländisch, Französisch, Spanisch)

475148

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Troubleshooting

Possible causes / Solutions:

 The plug has not been inserted far enough into the socket to make contact.

 There has been a power cut.

 The the fuse has blown. Try connecting another appliance to the same socket.

 If an extension cord is used, try connecting the dryer plug directly into the socket.

 The door has not been closed properly.

 The programme has not been set correctly (see How to carry out a drying cycle).

 The

START/PAUSE button has not been pressed (see How to carry out a drying cycle).

 A delayed start time has been set (see Programmes and options).

 The

START/PAUSE button has been pressed; a short delay follows before the

dryer starts running. Wait for the drying cycle to start; do not press the START/

PAUSE

button otherwise the dryer switches to the pause mode and the drying

cycle will not start.

 The filter has not been cleaned (see Care and maintenance).

 The heat setting is not suited to the type of fabric to be dried (see Programmes and

options).

 An incorrect drying time was selected for the type of load (see Laundry).

 The flexible ventilation hose may be blocked (see Installation).

 The air inlet may be blocked or obstructed (see Installation).

 The fixed ventilation flap, on the protective weatherproof cover, may be obstructed

(see Installation).

 The items are too wet (see Laundry).

 The dryer is overloaded (see Laundry).

 For safety reasons, the dryer programmes last a maximum of 4 hours. If an

automatic programme has not detected the final dampness level required in this

interval, the dryer completes the programme and stops. Check the above points

and repeat the programme; if the items are still damp, contact the Technical

Assistance Centre (see Assistance).

 Switch the appliance off and unplug it, then clean the filter (see Care and

Maintenance). Reinsert the plug, switch the appliance on and start another

programme.

If the problem persists, contact the Technical Assistance Service.

 This is normal, especially if the dryer has not been used for a long time. If the noise

persists during the entire cycle, contact the Technical Assistance Centre.

If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical

Assistance Centre

(see Assistance).

Problem:

The dryer does not start.

The drying cycle does not start.

Drying times are too long.

The programme is finished but

the items are damper than

expected.

The Options and START/

PAUSE indicator lights flash and

one of the Maintenance or

Drying phases indicator lights

turns on without flashing.

The dryer is noisy during the first

few minutes of operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit IDVA 835 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info