Bedienungsanleitung Indesit P640IB (Seite 13 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch)

512989

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

- Disconnect the appliance from the power supply in the

event of malfunction and always before cleaning or

maintenance;

- When not in use, disconnect the appliance from the

power supply and turn off the gas valve (if present);

- Always check to make sure that the control knobs are

on the “•”/”o” setting when the appliance is not in use;

Installation Instructions for built-in

The following instructions are intended for the installer so

that the installation and maintenance procedures may be

followed in the most professional and expert manner

possible. Important: Disconnect the appliance from the

electrical supply before performing any maintenance

or regulation upkeep work.

Positioning the Cooktop

Important: this unit may be installed and used only in

permanently ventilated rooms in accordance with British

Standard Codes Of Practice: B.S. 6172 / B.S. 5440, Par.

2 and B.S. 6891 Current Editions. The following

requirements must be observed:

a) The room must be fitted with a ventilation system which

vents smoke and gases from combustion to the outside.

This must be done by means of a hood or electric

ventilator that turns on automatically each time the hood

is operated.

In a chimney stack or branched flue. Directly to the Outside

(exclusively for cooking appliances)

b) The room must also allow for the influx of the air needed

for proper combustion. The flow of air for combustion

purposes must not be less than 2 m³/h per kW of

installed capacity. The supply of said air can be effected

by means of direct influx from the outside through a

duct with a inner cross section of at least 100 cm² which

must not be able to be accidentally blocked. Those

appliances which are not fitted with a safety device to

prevent the flame from accidentally going out must have

a ventilation opening twice the size otherwise required,

i.e. a minimum of 200 cm² (Fig. A). Otherwise, the room

can be vented indirectly through adjacent rooms fitted

with ventilation ducts to the outside as described above,

as long as the adjacent rooms are not shared areas,

bedrooms or present the risk of fire (Fig. B).

Detail A Adjacent Room to be

Room Vented

Examples of ventilation holes Enlarging the ventilation slot

for comburant air. between window and floor.

Fig. A Fig. B

c) Intensive and prolonged use of the appliance may ne-

cessitate supplemental ventilation, e.g. opening a

window or increasing the power of the air intake system

(if present).

d) Liquidified petroleum gases are heavier than air and,

as a result, settle downwards. Rooms in which LPG

tanks are installed must be fitted with ventilation

openings to the outside in order to allow the gas to

escape in the event of a leak. Therefore, LPG tanks,

whether empty or partially full, must not be installed or

stored in rooms or spaces below ground level (cellars,

ect.). It is also a good idea to keep only the tank

currently being used in the room, making sure that it is

not near sources of heat (ovens, fireplaces, stoves,

etc.) that could raise the internal temperature of the

tank above 50°C.

Installation of Built-in Cooktops

The gas cooktops are equipped with type X degree

protection against overheating. Therefore, the appliance

can be installed next to cabinets, provided the height of

the cabinet does not exceed that of the hob. For proper

installation of the cooktop, the following guidlines must be

followed:

a) If the cabinet(s) located next to the cooktop are higher

than the cooktop itself, the cabinet(s) must be installed

at least 600 mm from the edge cooktop;

b) Hoods must be installed in accordance with the

instructions contained in the installation manual for the

hoods themselves, and no less than 650 mm from the

cooktop;

c) The cabinets installed next to the hood must be located

at a height of at least 420 mm from the top, (as shown

in Fig. C).

- Cut the power supply cord after disconnecting it from

the electrical mains when you decide to no longer use

the appliance.

• The manufacturer will not be held liable for any

damages arising out of : incorrect installation or

improper, incorrect or unreasonable use..

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit P640IB Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info