Bedienungsanleitung Indesit taan 5 fnf fnf s (Seite 22 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

348882

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Troubleshooting

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.

Malfunctions:

The display is completely switched off.

The motor does not start.

The display is on but it is dim.

The alarm sounds, the ALARM LED

lights up and the refrigerator

compartment light flashes.

The alarm sounds, the ALARM LED

lights up and the freezer status bar

LEDs light up in sequence.

The alarm sounds, the ALARM LED

flashes and the freezer status bar

LEDs flash simultaneously.

The refrigerator and the freezer do not

cool well.

The food inside the refrigerator is

beginning to freeze.

The motor runs continuously.

The appliance makes a lot of noise.

Early ending of functions

The freezer status bar LEDs do not

indicate the set temperature, and are

lit in a constant manner.

Possible causes / Solutions:

 The plug has not been inserted into the electrical socket, or not far enough to

make contact, or there is no power in the house.

 The appliance comes with a motor protection control (see Start-up and use).

 Pull out and reverse the plug before putting it back in the socket.

 The refrigerator door has been open for more than two minutes.

The buzzer stops when the door is closed or when the ALARM button is

pressed.

 The temperature inside the freezer is too high. The freezer will maintain a

temperature of around 0°C so that the food will not refreeze, allowing you to eat

it within 24 hours or to refreeze it after it has been cooked.

To switch off the buzzer, press the ALARM button. Press a second time to

display the set value on the freezer status bar, switch off the ALARM LED and

restore normal operation.

 The temperature of the freezer is dangerously high: the food inside must not be

eaten. The freezer will maintain a temperature of approximately 0°C.

To switch off the buzzer, press the RESET ALARM button. Press a second time

to display the set value on the freezer status bar, switch off the ALARM LED and

restore normal operation.

 The doors do not close properly or the seals are damaged.

 The doors are opened too frequently.

 The temperature that has been set is too high (see Start-up and use).

 The refrigerator or the freezer have been over-filled.

 The temperature that has been set is too low (see Start-up and use).

 The SUPER FREEZE button has been pressed (rapid freezing): the yellow

SUPER FREEZE light is on or flashing (see Description).

 The door is not closed properly or is continuously opened.

 The outside ambient temperature is very high.

 The appliance has not been installed on a level surface (see Installation).

 The appliance has been installed between cabinets that vibrate and make noise.

 The internal refrigerant makes a slight noise even when the compressor is off.

This is not a defect, it is normal.

 Electrical disturbance on the network or brief interruptions of the power supply.

 Contact the Technical Assistance Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit taan 5 fnf fnf s Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info