Bedienungsanleitung Indesit tan 3 v (Seite 17 von 40) (Englisch, Französisch, Italienisch, Spanisch, Spanisch)

346593

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to

disconnect the appliance from the electricity supply:

It is not sufficient to set the temperature adjustment

knobs on

(appliance off) to eliminate all electrical

contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been

soaked in lukewarm water and bicarbonate of soda or

neutral soap. Do not use solvents, abrasive products,

bleach or ammonia.

• The removable accessories may be soaked in warm

water and soap or dishwashing liquid. Rinse and dry

them carefully.

• The back of the appliance may collect dust which can

be removed by delicately using the hose of a vacuum

cleaner set on medium power. The appliance must be

switched off and the plug must be pulled out before

cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic

materials which are odour free. In order to maintain an

odour free refrigerator and to prevent the formation of

stains, food must always be covered or sealed

properly.

• If you want to switch the appliance off for an extended

period of time, clean the inside and leave the doors

open.

Defrosting the appliance

! Follow the instructions below.

Do not speed up the defrosting process by using any

devices or tools other than the scraper provided, you

may damage the refrigeration circuit.

Defrosting the refrigerator compartment

The refrigerator has an

automatic defrosting

function: water is ducted

to the back of the

appliance by a special

discharge outlet (

see

diagram

) where the heat

produced by the

compressor causes it to

evaporate. It is necessary

to clean the discharge

hole regularly so that the water can flow out easily.

Defrosting the freezer compartment

Remove frost regularly using the special scraper

provided. If the frost layer is greater than 5 mm, it is

necessary to defrost manually:

1. Set the TEMPERATURE ADJUSTMENT knob to the

position

2. Wrap frozen foods in newspaper and place them in

another freezer or in a cool place.

3. Leave the door open until the frost has melted

completely. This can be made easier by placing

containers with lukewarm water in the freezer

compartment.

4. Clean and dry the freezer compartment carefully

before switching the appliance on again.

5. Wait for approximately 2 hours, i.e. until the ideal

storage conditions have been restored, before placing

food in the freezer compartment.

Replacing the light bulb

To replace the light bulb in the refrigerator compartment,

pull out the plug from the electrical socket. Follow the

instructions below.

Access the light bulb by

removing the cover as

indicated in the diagram.

Replace it with a similar

light bulb within the power

range indicated on the

cover (15W or 25W).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit tan 3 v Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info