Bedienungsanleitung Indesit WIAL143 (Seite 35 von 36) (Englisch, Holländisch, Französisch)

37727

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Troubleshooting

Your washing machine could fail to work. Before calling for Assistance (see page 36), make sure the problem

can't easily be solved by consulting the following list.

Problem

The washing machine won't

start.

The wash cycle won't start.

The washing machine fails to

load water.

The washing machine

continuously loads and unloads

water.

The washing machine does not

drain or spin.

The washing machine vibrates

too much during the spin cycle.

The washing machine leaks.

The ON-OFF/DOOR LOCK Led

flashes rapidly at the same

time as at least one other LED.

There is too much foam.

Possible causes/Solution:

 The appliance is not plugged into the socket, or not enough to

make contact.

 There has been a power failure.

 The appliance door is not shut properly.

 The

button has not been pressed.

 The START/RESET button has not been pressed.

 The water tap is not turned on.

 The water inlet hose is not connected to the tap.

 The hose is bent.

 The water tap is not turned on.

 There is a water shortage.

 The water pressure is insufficient.

 The START/RESET button has not been pressed.

 The drain hose is not fitted between 65 and 100 cm from the floor

(see page 27).

 The free end of the hose is underwater (see page 27).

 The wall drainage system doesn't have a breather pipe.

If the problem persists even after these checks, turn off the water tap,

switch the appliance off and call for Assistance. If the dwelling is on one

of the upper floors of a building, there may be drain trap problems

causing the washing machine to load and unload water continuously. In

order to avoid such an inconvenience, special anti-drain trap valves are

available in shops.

 The programme does not foresee the draining: some programmes

require enabling the draining manually (see page 30).

 The Easy iron option is enabled: to complete the programme, press

the START/RESET button (see page 31).

 The drain hose is bent (see page 27).

 The drain duct is clogged.

 The drum was not unblocked correctly during installation (see page 26).

 The washing machine is not level (see page 26).

 The washing machine is closed in between furniture cabinets and

the wall (see page 26).

 The water inlet hose is not screwed on correctly (see page 26).

 The detergent dispenser is obstructed (to clean it, see page 34).

 The drain hose is not secured properly (see page 27).

 Switch off the machine and unplug the appliance; wait for

approximately 1 minute then switch it on again.

If the problem persists, contact Assistance.

 The detergent is not suitable for machine washing (it should bear the

definition "for washing machines" or "hand and machine wash", or the like).

 You used too much detergent.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit WIAL143 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Indesit WIAL143

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info