Bedienungsanleitung Indesit WIDL 126 (EX) (Seite 23 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

4578

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Troubleshooting

ServiceTroubleshootingPrecautions CareProgrammes DetergentsInstallation Description

Your Washer-dryer could fail to work. Before calling for Assistance (see page 24), make sure the problem can't

easily be solved by consulting the following list.

Problem

The washer-dryer won't start.

The wash cycle won't start.

The washer-dryer fails to load

water.

The washer-dryer continuously

loads and unloads water.

The washer-dryer does not

drain or spin.

The washer-dryer vibrates too

much during the spin cycle.

The washer-dryer leaks.

The ON-OFF/DOOR LOCK Led

flashes rapidly at the same

time as at least one other LED.

There is too much foam.

The washer-dryer does not dry.

Possible causes/Solution:

 The appliance is not plugged into the socket, or not enough to

make contact.

 There has been a power failure.

 The appliance door is not shut properly.

 The

button has not been pressed.

 The START/RESET button has not been pressed.

 The water tap is not turned on.

 A delayed start has been set (using the Delay Timer, see page 19).

 The water inlet hose is not connected to the tap.

 The hose is bent.

 The water tap is not turned on.

 There is a water shortage.

 The water pressure is insufficient.

 The START/RESET button has not been pressed.

 The drain hose is not fitted between 65 and 100 cm from the floor

(see page 15).

 The free end of the hose is underwater (see page 15).

 The wall drainage system doesn't have a breather pipe.

If the problem persists even after these checks, turn off the water tap,

switch the appliance off and call for Assistance. If the dwelling is on one of

the upper floors of a building, there may be drain trap problems causing the

Washer-dryer to load and unload water continuously. In order to avoid such

an inconvenience, special anti-drain trap valves are available in shops.

 The programme does not foresee the draining: some programmes

require enabling the draining manually (see page 18).

 The Easy iron option is enabled: to complete the programme, press

the START/RESET button (see page 19).

 The drain hose is bent (see page 15).

 The drain duct is clogged.

 The drum was not unblocked correctly during installation (see page 14).

 The Washer-dryer is not level (see page 14).

 The Washer-dryer is closed in between furniture cabinets and

the wall (see page 14).

 The water inlet hose is not screwed on correctly (see page 14).

 The detergent dispenser is obstructed (to clean it, see page 22).

 The drain hose is not secured properly (see page 15).

 Call for Assistance because this means there is an abnormality.

 The detergent is not suitable for machine washing (it should bear

the definition "for washing machines" or "hand and machine wash",

or the like).

 You used too much detergent.

 The appliance is not plugged into the socket, or not enough to make contact.

 There has been a power failure.

 The appliance door is not shut properly.

 A delayed start has been set (using the Delay Timer, see page 19).

 the DRYING knob is on the 0 setting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit WIDL 126 (EX) Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info