Bedienungsanleitung Indesit WIL 1400 (Seite 6 von 36) (Englisch, Holländisch, Französisch)

75440

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Running a wash cycle

Note: After installing the machine and before using

it for the first time, run an empty wash cycle using

detergent, setting the

programme and ensuring

the timer knob is in the "auto" position.

1. Switch the washing machine on by pressing

ON/OFF button

. All the LEDS will light up for a

few seconds and the ON-OFF/DOOR LOCK

indicator light

will begin to flash.

2. LOADING LAUNDRY. Open the door. Load the

laundry, making sure that the maximum load

quantity indicated in the table of programmes

(below) is not exceeded.

3. MEASURING OUT DETERGENT/WASHING ADDITIVES

Remove the drawer completely and pour the

detergent into the compartment marked with the

number 2. If required, pour fabric softener and

other additives into the compartment marked with

the number 3. The softener must not rise above

the level of the grille. If you wish to run the

washing programme especially for sportswear

(by setting the timer knob to "auto" or to one of

the positions between "3h and 24h" - see

Detergents and laundry), it is also possible to

use powder detergent in compartment 1 for the

pre-wash phase.

4. CLOSE THE DOOR.

5. SELECT THE WASH FABRIC by turning the

PROGRAMME KNOB right or left until the correct

fabric or the "Rinse" programme is selected.

6. SET THE WASHING END TIME by turning the

TIMER KNOB right or left.

The following settings may be used:

- Positions "30 min - 45 min - 60 min": by

selecting one of these times, the duration of the

programme is set.

- Positions between "3h" and "24h": by selecting

one of these times the user selects the number of

hours after which the programme should finish.

The effective duration of the wash is equivalent to

the "auto" cycle duration (see table of

programmes below), but the machine will delay

the start of the cycle automatically to ensure it

ends within the set time period.

- Whenever it is not necessary to set a specific

time for washing to end, select the "AUTO"

position: the machine automatically controls the

duration of the programme, based on the fabric

selected (see table of programmes below).

Regardless of the position selected for the TIMER

KNOB, the "Rinse"

programme lasts 15

minutes and begins as soon as the START/

CANCEL

button is pressed.

7. START THE PROGRAMME by pressing the

START/CANCEL

button. The "on-off/door lock"

and "programme in progress" indicator lights

will illuminate and remain lit constantly.

During the cycle, the indicator lights provide

information relating to the amount of time

remaining until the end of the programme.

When there are 30, 20 and 10 minutes

respectively remaining until the end of the

programme, the corresponding indicator lights will

illuminate.

8.PROGRAMME END

At the end of the wash programme, all the

indicator lights will switch off. Wait for the door to

become unlocked (the "on-off/door lock"

indicator light flashes), remove the laundry and

leave the door ajar in order to let the drum dry

out. Switch off the machine by pressing the ON/

OFF

button.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit WIL 1400 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info