Bedienungsanleitung Indesit YT M08 71 R (Seite 1 von 4) (Englisch)

684554

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

PUSH & GO

This function serves to start a cycle, after machine switching on,

without enabling any further button an/or knob (the programme

PUSH & GO will be deactivated instead).

It is always necessary to follow the points 1, 2, and 3 concerning

the daily use.

To start the cycle Touch & GO, keep the button pressed. The light on

signals that the cycle is started. The cycle is suitable for cotton and

synthetic textiles. Max. load 4 kg. (Cycle duration 140’).

If the door is opened during the cycle, to restart it, close the door and

press the button START/PAUSE. This programme does not allow to set

other options.

OPENING OF THE DOOR DURING THE CYCLE

During operation, it is possible to open the door. After having closed it,

press the button Start/Pause again to restart the dryer.

FIRST TIME USE

Make sure that the water tank is correctly inserted. Make sure

that the drain hose on the back of the dyrer is properly xed,

either to the dryers's water tank or to the domestic sewage

system.

The dryer should be installed in environment in a room

temperature range of 20°to 23°C for optimum performance. But

will function if the room is between 14 and 30°C. Before you use

your dryer ensure that it has been in a upright position for at

least 6 hours.

DAILY USE

Doing this will keep your machine working at its BEST!

Remember to empty your water tank after each drying cycle.

Remember to clean your lters after each drying cycle. (Refer to

section Care & Maintanence).

1. Open the door and load garments. Always refer to instructions

on clothing labels and the max loads indicated in the programme

section. Empty pockets. Make sure garments do not get caught

between the door and/or the door lter.

2. Close the door.

3. Press the button On/O .

4. Select the programme according to the laundry type.

5. Select the options, if necessary.

6. To start the cycle, press the Start/Pause button.

7. At the end of the drying cycle, a buzzer will beep. An indicator on

the control panel signals the end of the cycle. Pull the load out

immediately to prevent the formation of creases on laundry.

8. Turn the machine o by pressing the button On/O, open the

door and pull clothing out. If the machine is not switched o

manually, after about a quarter of an hour from the cycle end, the

appliance turns o automatically to save energy.

If this last stage is not carried out immediately, some machines

and/or some programmes/options are equipped with Crease Care

system. For some hours, after the end of drying, the drum rotates at

regular intervals to prevent the formation of creases.

In case of power failure, it is necessary to press the button Start/

Pause to restart the cycle.

*MAX LOAD 7 Kg (Dry load)

CARE LABEL

Always check the care labels, especially when placing garments in

the tumble dryer for the  rst time. Below are the most commonly

used symbols:

May be tumble dried.

Do not tumble dry.

Tumble dry – high heat.

Tumble dry – low heat.

You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:

• Visiting our website - docs.indesit.eu

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When

contacting our After-sales Service, please state the codes provided on your product’s identi cation plate.

THANK YOU FOR BUYING A INDESIT PRODUCT.

In order to receive a more complete assistance,

please register your product on

www.indesit.eu/register

Quick guide

Before using the appliance carefully read the Safety Instructions.

xxxxxxxxxxxx

xxxx

Start delay

Gentle/crease care

Key lock

08-05-2017

Indesit_Tilt_Mono_Dryer_M08

08-05-2017

Indesit_Tilt_Mono_Dryer_M08

Start delay

Gentle/crease care

Key lock

08-05-2017

Indesit_Tilt_Mono_Dryer_M08

6h3h 9h

3”

6h3h 9h

3”

6h3h 9h

Dry time

Specials

120 min

90 min

60 min

30 min

Cotton

Synthetics

ShoeRack

Mixed

extra

3”

+++

7kg

Key lock

6h3h 9h

3”

CONTROL PANEL

1 ON/OFF button (Reset if long pressed)

2 Programme selection knob

3 Start/Pause button (Start: button lights up solidly. Pause: button

blinks)

4 Push & GO

Options Buttons*

5 Start delay

6 Crease care

7 Key lock

*Note: some models may have the wording in full instead of the icons

INDICATORS

Cycle phase: Dry - Cool tumble - END End of cycle

When the same indicators of the cycle phase are blinking, they show the start delay of the programme set.

Empty water tank Clean door lter Clean bottom lter

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit YT M08 71 R Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Indesit YT M08 71 R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info