Bedienungsanleitung InFocus IN105 (Seite 32 von 55) (Englisch)

540584

Zoom out

Zoom in

Vorherige Seite

1/55

Nächste Seite

Operation32

3D Color Management

In most installation situations, color management will not be necessary, such as in

classroom, meeting room, or lounge room situations where lights remain on, or

where building external windows allow daylight into the room.

Only in permanent installations with controlled lighting levels such as boardrooms,

lecture theaters, or home theaters, should color management be considered. 3D

Color Management provides fine color control adjustment to allow for more

accurate color reproduction, should you require it.

Proper color management can only be achieved under controlled and reproducible

viewing conditions. You will need to use a colorimeter (color light meter), and

provide a set of suitable source images to measure color reproduction. These tools

are not provided with the projector, however, your projector supplier should be able

to provide you with suitable guidance, or even an experienced professional installer.

3D Color Management provides six sets (RGBCMY) of colors to be adjusted.

When you select each color, you can independently adjust its range and saturation

according to your preference.

If you have purchased a test disc which contains various color test patterns and can

be used to test the color presentation on monitors, TVs, projectors, etc. You can

project any image from the disc on the screen and enter the 3D Color

Management menu to make adjustments.

To adjust the settings:

1. Go to the PICTURE menu and highlight 3D Color Management.

2. Press MODE/ENTER and the 3D Color Management page displays.

3. Highlight Primary Color and press / to select a color from among Red,

Yellow, Green, Cyan, Blue, or Magenta.

4. Press to highlight Hue and press / to select its range. Increase in the

range will include colors consisted of more proportions of its two adjacent

colors.

Please refer to the illustration to the right

for how the colors relate to each other.

For example, if you select Red and set its

range at 0, only pure red in the projected

picture will be selected. Increasing its

range will include red close to yellow and

red close to magenta.

5. Press to highlight Saturation and

adjust its values to your preference by

pressing / . Every adjustment made

will reflect to the image immediately.

For example, if you select Red and set its

value at 0, only the saturation of pure red will be affected.

6. Press to highlight Gain and adjust its values to your preference by

pressing / . The contrast level of the primary color you select will be

affected. Every adjustment made will reflect to the image immediately.

7. Repeat steps 3 to 6 for other color adjustments.

8. Make sure you have made all of the desired adjustments.

9. Press MENU/EXIT to exit and save the settings.

RED

BLUE

GREEN

Yellow

Cyan

Magenta

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

InFocus IN105 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von InFocus IN105

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info