537554
30
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
29
Controlling the projector through a LAN
environment
The projector supports Crestron
®
software. With correct settings for the
Network menu, you can manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the
same local area network.
Wired connection
Internet
IP Router
Configuring the LAN control setting
If you are in a DHCP environment:
1 Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the
projector and the other end to the RJ45 port.
2 Press Menu on the keypad or remote and then go to Advanced Menu > Setup
> Network > Wired LAN menu.
3 Press v to highlight DHCP and press < or > to select On.
4 Press v to highlight Apply and press >.
5 Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN
page. The IP address, Subnet Mask, Default Gateway and DNS settings will be
displayed. Write down the IP address displayed in the IP address row.
If the Projector IP Address still does not display, contact your network
administrator.
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway and DNS settings will display 0.0.0.0. Make sure the cables
are properly connected and perform the procedures above again.
If you need to connect to the projector in its standby mode, set the Power
Saving Mode feature to Off.
If you are in a non-DHCP environment:
1 Repeat steps 1-2 above.
2 Press v to highlight DHCP and press < or > to select Off.
3 Contact your network administrator for information on the IP address, Subnet
Mask,
Default Gateway and DNS settings.
4 Press ^ or v to select the item you want to modify.
5 Press < or > to move the cursor and then press ^ or v to select the value.
6 Press v to highlight Apply and press > to save the settings.
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway and DNS settings will display 0.0.0.0. Make sure the cables
are properly connected and perform the procedures above again.
If you wish to connect to the projector in its standby mode, be sure to
select RJ45 and obtain the IP Address, Subnet Mask, Default Gateway and
DNS information when the projector is on.
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für InFocus IN3128HD wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von InFocus IN3128HD

InFocus IN3128HD Bedienungsanleitung - Deutsch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Holländisch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Französisch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Italienisch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Portugiesisch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Spanisch - 45 seiten

InFocus IN3128HD Bedienungsanleitung - Schwedisch - 45 seiten

InFocus IN3128HD Kurzanleitung - Alle Sprachen - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info