Bedienungsanleitung Innoliving INN-681 (Seite 20 von 24) (Englisch, Italienisch)

800627

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

FILLING THE WATER TANK

1) Make sure the iron is turned off and unplugged from the mains.

2) Check that the steam control button is in the “steam OFF” position.

3) Position the iron on the base and remove the tank by pulling it with the specific handle.

4) Fill the special graduated container with water and carefully pour the water into the tank.

5) Reposition the water tank on the base, up to the position where you hear a click.

Attention: It is recommended to use demineralized water to fill the water tank rather than

tap water, as tap water with more impurities and minerals can create limescale, which can

damage the iron.

Warning: do not fill the tank with hot water.

Warning: never add descaling, aromatic, alcoholic or detergent products into the appliance,

as this could damage the appliance or make it dangerous to use.

USING THE IRON

After filling the water tank, wait 5 minutes to give the filter the time necessary to transform

hard water into soft water, to preventi calcification.

STEAM IRON

When steam ironing for the first time, it is recommended to test on a smooth cloth first to

check that the iron is operating at the correct temperature. Try this without using the steam

mode.

1) Fill the tank following the instructions in the “Filling the tank” section.

2) Connect the iron to the mains and turn the temperature control knob clockwise.

3) To increase the temperature of the iron, turn the regulator clockwise to the desired

temperature level. Reduce the temperature by turning the regulator anti-clockwise. The

temperature indicator light turns on to signal that the iron is heating up; this indicator

goes off when the iron is ready for use.

4) Select the steam setting by pressing and holding the steam button. The steam can be

deactivated at any time by releasing the steam button.

5) Press the “Continuous steam lock” button to have steam continuously, without pressing

the steam button.

6) After use, turn the temperature regulator to ‘MIN’, then disconnect the steam iron from

the mains.

Attention: To produce steam, the temperature regulator must be set to at least the second

temperature level.

Warning: When the iron is not in use, make sure it is placed on its base.

Attention: Do not iron the same area of the fabric for a long time, this can damage the fabric.

Warning: The cable coming out of the iron can become very hot during use, do not touch it.

IRON WITHOUT STEAM

1) The water tank does not need to be filled if you iron without steam; if full The water tank

does not need to be filled to iron without steam; if it is full, it can be emptied or left so that

it is ready for the next use with steam.

2) Plug in the iron and turn the steam control clockwise

3) To increase the temperature of the iron, turn the regulator clockwise to the desired

temperature level. Reduce the temperature by turning the regulator anti-clockwise. The

temperature indicator light turns on to signal that the iron is heating up; this indicator

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Innoliving INN-681 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info