Bedienungsanleitung Insignia NS-R2001 (Seite 17 von 20) (Englisch)

590371

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Insignia NS-R2001 AM/FM Stereo Receiver

www.insigniaproducts.com

Maintaining

To clean this receiver, wipe with a soft, dry cloth. If

the surfaces are extremely dirty, use a soft cloth

dipped in a soap and water solution or a weak

detergent solution.

• Never use alcohol, paint thinner, or benzine to

clean this receiver.

• Before using a chemically treated cloth, read the

instructions that came with the cloth carefully.

Troubleshooting

If a problem occurs, run through the table below

before contacting Insignia.

If the problem persists, attempt to solve it by

switching the receiver off and on again. If this fails

to resolve the problem, contact Insignia. Under no

circumstances should you attempt to repair the

receiver yourself as this could void the warranty.

Category Problem Possible Solution

No power.

•The AC power cord is

disconnected.

• Poor connection at AC wall

outlet or the outlet is

inactive.

• Connect the cord securely.

• Check the outlet using a lamp or

another appliance.

No sound.

• The speaker cords are loose

or disconnected.

• The volume is adjusted too

low.

•The MUTE button on the

remote control is pressed to

ON.

• Speakers are not switched

on.

• Incorrect selection of the

input source.

• Incorrect connections

between the components.

• The correct speaker is not

selected.

• Check the speaker connections.

• Adjust the volume.

•Press the MUTE button to cancel the

muting effect.

• Turn on one or both speakers.

• Select the desired input source

correctly.

• Make connections correctly.

•Press SPEAKER A or B to select the

correct speakers.

Stations cannot

be received.

• No antenna is connected.

• The desired station

frequency is not tuned in.

• The antenna is in wrong

position.

• Connect an antenna.

• Tune in the desired station

frequency.

• Move the antenna and retry tuning.

Preset stations

cannot be

received.

•An incorrect station

frequency has been

memorized.

•The memorized stations are

cleared.

• No antenna is connected.

• The antenna is not

positioned for the best

reception.

• The receiver is not in

PRESET mode.

• Memorize the correct station

frequency.

• Memorize the stations again.

• Connect an antenna.

• Change the position of the

• antenna.

•Press TUNE/PRESET until the

PRESET indicator lights.

Poor FM

reception.

• No antenna is connected.

• The antenna is not

positioned for the best

reception.

• The antenna connection

may not to secure.

• You may not be fully tuned

to the correct frequency.

• Connect an antenna.

• Change the position of the antenna.

• Make sure that the antenna is

properly secured.

• Make sure that you are tuned to the

correct frequency.

• Try using an outdoor antenna.

Continuous

hissing noise

during FM

reception,

especially

when a stereo

broadcast is

received.

•Weak signals.

• The antenna connection

may not to secure.

• You may not be fully tuned

to the correct frequency.

• The receiver may be too

close to a TV or another

appliance.

• Change the position of the antenna.

• Install an outdoor FM antenna.

• Make sure that the antenna is

properly secured.

• Make sure that you are tuned to the

correct frequency.

• Move the devices or turn them off.

• Try using an outdoor antenna.

Continuous or

intermittent

hissing noise

during AM

reception,

especially at

night.

Noise is caused by motors,

fluorescent lamps, or

lightning.

• Keep the receiver away from noise

sources.

• Install an outdoor AM antenna.

No recording.

• Incorrect selection between

the components.

• Incorrect operation of each

component for playback and

recording.

• Make connections correctly.

• Operate each component correctly.

There is noise

or a humming

sound.

• The receiver may be too

close to a TV or another

appliance.

• Connect the turntable’s ground cord

to the PHONO GND terminal.

• Move the devices or turn them off.

The sound lacks

bass.

• The speaker polarity (+/–)

might be reversed.

• Check all speakers for correct

polarity.

The volume of

SPEAKER A is

different from

that of

SPEAKER B.

•The volume and sound

quality may differ

depending on the speaker’s

size, etc.

• Connect the same type of speakers

to the SPEAKERS A and B terminals if

you want to use SPEAKERS A and B at

the same time with the same

volume.

I can hear the

audio, but I

can’t see the

video on my TV.

• The correct video input on

the TV is not selected.

• Select the input source that matches

the device connected to the TV.

Remote control

unit does not

operate.

• Batteries are not installed or

are dead.

• The remote sensor is

obstructed.

• Replace the batteries.

• Remove the obstacle.

Category Problem Possible Solution

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Insignia NS-R2001 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info