Step 15: Insert L/E cable into hole at bottom of Floating
Pulley Bracket. Secure with Cable Adapter and Pulley 19.
Tighten Now. Tighten Step 13 Now.
Note: Be sure to feed the L/E
Cable between the 2 small
pulleys and over the small plate
behind the 2 small pulleys, as
the L/E and Cam are attached.
Step 13: Attach Pulleys 12 & 13 to Main Upright.
Step 14: Remove the 4 Flat Head Cap Screws
and Cam Plate from the L/E Cam. Next, using the
same 4 Flat Head Screws and the Cam Plate,
attach the Leg Extension Cable to the L/E Cam as
shown in the circle diagram. Tighten Now!
Attach L/E Cam and L/E Assembly to the front of
Main Base (Lower Numbers on Cam should be on
top). See Note! Tighten Now, Do Not Over
Tighten. L/E Assembly should swivel freely.
Route L/E cable behind Pulley 3, down to front of &
under Pulley 4 (make sure cable is routed between
the cable retainer pin and pulley on Pulleys 4 & 2),
back under & up around Pulley 2, to Floating
Pulley Bracket. Go to Step 15 above.
