Bedienungsanleitung Intempo EE1161 (Seite 6 von 24) (Englisch, Holländisch, Französisch)

807957

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Instructions for Use

Charging the Battery

The Valise Audio Turntable is ﬁtted with a 3.7 V 1200 mAh

li-ion battery. It is recommended that the battery be charged fully

before ﬁrst use; this will take approximately 6 hours.

Connect the DC input end of the USB charging cable into the

5 V 1 A DC charging port on the back of the Valise Audio

Turntable and the other end to a compatible 5 V 1 A USB port.

Whilst charging, the LED indicator light will illuminate green.

Once the battery has charged fully, the charging indicator light

will turn off.

Once the Valise Audio Turntable is fully charged, carefully

disconnect both ends of the USB charging cable and store it

safely for future use.

Note: The Valise Audio Turntable can still be operated whilst

charging the battery but may take longer to fully charge.

Using the Valise Audio Turntable

Basic Functionality

Turn on the Valise Audio Turntable by rotating the ‘On/Off

Volume Dial’ in a clockwise direction.

The dial will also adjust the volume of the Valise Audio

Turntable. Turn the ‘On/Off Volume Dial’ in a clockwise

direction to increase the volume. Decrease the volume by

twisting the ‘On/Off Volume Dial’ in an anticlockwise direction.

Choose either the ‘Turntable’ or ‘Bluetooth’ mode using the

‘Mode Selection Switch’ (see below sections entitled ‘ Listening

to a Vinyl Record’ or ‘Listening through the Bluetooth’ mode).

Rotate the ‘On/Off Volume Dial’ in an anticlockwise direction

until it clicks, to turn off the Valise Audio Turntable.

Modes

Ensure that the Valise Audio Turntable is turned on before using

any of the following modes.

Turntable Mode

Listening to a Vinyl Record

STEP 1: Turn on the Valise Audio Turntable by rotating the

‘On/Off Volume Dial’ in a clockwise direction.

STEP 2: Select the Turntable mode using the ‘Mode

Selection Switch’.

STEP 3: Remove the protective white needle cover by gently

sliding it away from the tone arm (Diagram 1).

STEP 4: Carefully place a record onto the turntable,

remembering to apply the 45 rpm adaptor ﬁrst, if listening to a

45 rpm record with a large centre hole.

STEP 5: Unlock the tone arm from the arm lock by pushing it aside.

STEP 6: Raise the tone arm using the arm raising lever or by

carefully lifting it.

STEP 7: Move the tone arm across to the outer edge of the

record and gently lower it; the turntable will begin to spin and

play automatically.

STEP 8: Once the tone arm reaches the end of the record at the

centre of the turntable, the turntable will stop. Lift away the tone

arm and place it back into the armrest.

STEP 9: Secure the tone arm once more by engaging the arm lock.

STEP 10: Rotate the ‘On/Off Volume Dial’ in an anticlockwise

Diagram 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intempo EE1161 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info