Bedienungsanleitung Intex ECO 7110 Krystal Clear (Seite 12 von 28) (Englisch)

686156

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

(260PO) MODEL ECO7110&8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/29/2016

260

SAVE THESE INSTRUCTIONS

English

Page 12

SALT & POOL WATER VOLUMES

• Whichkindofsalttouse:

Use only Sodium Chloride Salts

Useonlysodiumchloride(NaCl)saltthatisatleast99.8%pure.Itisalsoacceptabletouse

waterconditioningsaltpellets(thecompressedformsofevaporatedsalt).However,itwilltakea

longer time for them to dissolve.

Do not use iodized or yellow (yellow prussiate of soda) colored salt.

Salt is added to the pool water and the electrolytic cell uses the salt to create chlorine. The purer

the salt the better the performance of the electrolytic cell.

• OptimumSaltLevels

Theidealsaltlevelinthepoolwaterisbetween2500-3500ppm(partspermillion).Theoptimal

level is 3000 ppm.

A too low salt level will reduce the efficiency of the Saltwater System and result in low chlorine

production.Ahighsaltlevelmaygenerateasaltytastetothepoolwater(thismayoccuratasalt

levelabove3500-4000ppm).Toohighasaltlevelmaydamagethepowersupplyandcause

corrosion to the pool metal fixtures and accessories. The Salt Table page of this manual, shows

the correct dosage of salt needed. The salt in the pool is constantly recycled. The loss of salt is

due only to pool water being physically removed from the pool. Salt is not lost due to

evaporation.

• AddingSalt

. Switch the filter pump on to start the water circulation.

. Keep the Saltwater System turned off.

. Determinetheamountofsalttobeadded(see“SaltTable”).

. Evenly spread the proper amount of salt around the inside perimeter of the pool.

. Avoid clogging the filter. Do not add salt through the skimmer.

. Brushthepoolbottomtospeedupthedissolvingprocess.Donotallowsalttopileuponthe

bottom of the pool. Run the filter pump 24 consecutive hours to thoroughly dissolve the salt.

. After 24 hours and if all the salt is dissolved, turn on the Saltwater System, press button

until you hear a “beep”, code “00” flashing and set the saltwater pool system to desired

 operatingtime(see“OperatingTimeTable”).

• RemovingSalt

Iftoomuchsalthasbeenadded,theunitwillbeepanddisplay“Code92”(see“AlarmCodes”).

You will need to lower the salt concentration. The only way to do so, is to partially drain the pool

andrefillitwithfreshwater.Drainandrefillapproximately20%ofthepool’swateruntilthe“Code

92” disappears.

• PoolVolumeCalculation

Rectangular

Length x Width x Average Depth x 7.5 Length x Width x Average Depth

Circular

Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79

Oval

Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80

Types of Pool

Gallons

(poolsizeinfeet)

Cubic Meters

(poolsizeinmeters)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex ECO 7110 Krystal Clear Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info