Bedienungsanleitung Intex ECO7111 (Seite 11 von 29) (Englisch)

686151

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

SAVE THESE INSTRUCTIONS

Page 2

(249PO) MODEL ECO7111 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 05/25/2016

English

249

S AVE THESE INSTRUCTIONS

English

Page 11

SALT & POOL WATER VOLUMES

• Whichkindofsalttouse:

Use only Sodium Chloride Salts

Useonlysodiumchloride(NaCl)saltthatisatleast99.8%pure.Itisalsoacceptabletouse

water conditioning salt pellets (the compressed forms of evaporated salt). However, it will take

a longer time for them to dissolve.

Do not use iodized or yellow (yellow prussiate of soda)

colored salt.

Salt is added to the pool water and the electrolytic cell uses this salt to create the

sanitizer. The purer the salt the better the performance of the electrolytic cell.

• OptimumSaltLevels

Theidealsaltlevelinthepoolwaterisbetween2500-3500ppm(partspermillion).Theoptimal

levelis3000ppm.

A too low salt level will reduce the efficiency of the saltwater system and result in low sanitizer

production. A high salt level may generate a salty taste to the pool water (this may occur at a salt

levelabove3500-4000ppm).Toohighofasaltlevelmaydamagethepowersupplyandcause

corrosion to pool metal fixtures and accessories. The Salt Table page of this manual, shows the

correct dosage of salt needed. The salt in the pool is constantly recycled. Salt loss occurs only

when pool water is physically removed from the pool. Salt is not lost due to evaporation.

• AddingSalt

Switch on the unit, then press and hold both and button for 5 seconds, the LED

flashes “FP”. The unit is now in a Filter pump working mode and switch the filter pump on to

start the water circulation.

Keep the saltwater system turned off.

Determine the amount of salt to be added (see “Salt Table”).

Evenly spread the proper amount of salt around the inside perimeter of the pool.

Avoid clogging the filter by not adding salt through the skimmer.

Brush the pool bottom to speed up the dissolving process. Do not allow salt to pile up on the

bottom of the pool. Run the filter pump 24 consecutive hours to thoroughly dissolve the salt.

After 24 hours and if all the salt is dissolved, turn on the Saltwater System, press button

until you hear a “beep”, code “00” flashing (see “System Operation” section steps 2 to 4) and

set the saltwater system to desired operating time (see “Operating Time Table”).

• RemovingSalt

If too much salt has been added, the unit will beep and display “code 92” (see “Alarm Codes”).

You will need to lower the salt concentration. The only way to do so, is to partially drain the pool

andrefillitwithfreshwater.Drainandrefillapproximately20%ofthepool’swateruntilthe“Code

92” disappears.

• PoolVolumeCalculation

Rectangular

Length x Width x Average Depth x 7.5 Length x Width x Average Depth

Circular

Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79

Oval

Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80

Types of Pool

Gallons

(pool size in feet)

Cubic Meters

(pool size in meters)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex ECO7111 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info