752324
9
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
344
NLA
S AVE THESE INSTRUCTIONS
(344NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2019
English
Page 9
PRODUCT SPECIFICATIONS
SET UP
RF frequency band: 2408~2476MHz Transmitter power: 10dBm
In atable, portable aboveground cord-connected spa with pump, heater, water jet, blower, control panel,
built-in hard water treatment, and sanitation system.
Note: the spa equipment features a complete grounding system that is also in contact with the spa water. It
is possible that a person may build up static electricity that discharges when touching the water. Regardless,
any electric shock experienced should be investigated by a quali ed electrician prior to use of the spa.
Unplug the spa until the cause is determined and any corrective action completed.
Hereby, Intex Development Company Limited, declares that this SC-20/SC-20N is in compliance with the
essential requirements and other relevant provisions of Derective 2014/53/EU.
Site preparation and requirements
The spa can be installed indoor or outdoor. For household use only.
Make sure the area is water resistant, level, at and free of sharp objects under or around the spa.
Provide a properly located grounded electrical outlet with a protection grade of IPX4 or higher to connect
the spa and allow easy access for periodic testing of the cord mounted RCD.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
The area shall facilitate draining purposes during long term spa storage. Check local and national
regulations regarding spa water disposal requirements.
To reduce noise disturbance, do not install the spa in the immediate vicinity of vertical walls.
The area shall be within reach of fresh water supply in compliance with local water regulations, and whose
parameters shall be adjusted according to the spa water chemistry and balance section of the manual
before rst use of the spa.
Check your local laws and regulations regarding indoor and/or outdoor spa installation.
Additional requirements for indoor installation
Make sure the oor can support the full weight of the lled spa with the maximum number of occupants.
Check with a quali ed contractor or a structural engineer to verify this requirement.
Make sure the oor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
Do not install the spa indoors on a second oor above nished living space due to the possibility of water
and humidity damage.
Maximum seating capacity: 4 adults 6 adults
Voltage / Frequency / Phase 220 – 240 V / 50 Hz / 1 PH
Water capacity: 210 gal (795 L) 290 gal (1098 L)
Inner/outer diameter: 59/79 in (150/201 cm) 66/86 in (168/218 cm)
Height: 28 in (71 cm)
Jet pump: 1000 Watts
Bubble air blower: 800 Watts
Filter pump ow rate: 460 gal/hr (1,741 L/hr)
Heater power: 2,200 Watts
Temperature range: 10ºC – 40ºC (50ºF – 104ºF)
Temperature rise: 1.5-2.5ºC/hr (3ºF – 4.5ºF/hr) 1-2ºC/hr (2ºF – 3.5ºF/hr)
Number of Water Jet Nozzles: 4 6
Number of Bubble Jets: 120 140
Spa tub recommended working air pressure: 0.083 bar (1.2 psi)
WARNING
Risk of re: This product draws a minimum of 13 AMPS. Most household circuits are 13 to
16 AMPS. If the circuit breaker trips, please check that no other appliances or other large
loads are on the same circuit as the spa. Never use an extension cord. Unfold the line cord
prior to use. Never place the plug on combustible materials.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

intex-pure-spa-sb-h20

Suche zurücksetzen

  • Konstantes Signal, aber kein Fehlercode ersichtlich; sonstige Funktionen in Ordnung. Eingereicht am 21-6-2024 11:26

    Antworten Frage melden
  • Wie wird der schwarze pumpenschlauch zum aufpumpen bei SB-H20 befestigt Eingereicht am 9-7-2023 12:27

    Antworten Frage melden
  • Woher kann ich das passende Überdruckventil bekommen. Eingereicht am 26-6-2023 19:40

    Antworten Frage melden
  • Fehler E 90 wird angezeigt. Pumpe läuft nicht. Filter schon gewechselt. Eingereicht am 11-3-2023 12:39

    Antworten Frage melden
  • Ich benötige für diesen Artikel das Inlet der Poolabdeckung, wie bekomme ich das ? Eingereicht am 14-6-2022 11:47

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Intex Pure Spa SB-H20 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Intex Pure Spa SB-H20

Intex Pure Spa SB-H20 Bedienungsanleitung - Deutsch - 34 seiten

Intex Pure Spa SB-H20 Bedienungsanleitung - Holländisch - 35 seiten

Intex Pure Spa SB-H20 Bedienungsanleitung - Französisch - 34 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info