Bedienungsanleitung Intex PureSpa - 28404GN (Seite 12 von 21) (Englisch)

686037

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

254

S AVE THESE INSTRUCTIONS

(254IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 01/28/2016

English

Page 12

OPERATION

SPA CONTROL UNIT PANEL

On/Off Button: Once the unit is plugged in, use this button to active the control unit panel

buttons. The light next to the button is green when activated. Press this button to turn off all

currently activated functions.

NOTE: The On/Off button may appear as a black button in the center of the control panel.

Heat Button: Use this button to activate the heating system. The pump will heat the spa water

until the water temperature reaches the set temperature. When the spa water temperature drops

1-2°C (1.8-3.6°F) below the set temperature the heating system will restart. When the ﬂ ame icon

on the display is red, the heating system is activated. When the ﬂ ame icon turns green, the

water is at the set temperature. The heating system is at rest and the ﬁ ltration system will

continue working nonstop.

NOTE: To stop the ﬁ ltration system while the heater is at rest mode, press the ﬂ ame button ﬁ rst

and then the ﬁ lter button. Pressing the ﬂ ame button only while the heater is at rest mode will

turn off the heating system only and the ﬁ ltration system will operate for another 24 hours before

it turns off automatically.

Celsius/Fahrenheit Toggle button:

The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is

Celsius.

CAUTION: NEVER use the spa if indicated water temperature is more than 40°C (104ºF).

Temperature Adjustment Buttons: Pressing the Temperature Increase or Decrease

buttons will cause the LED to ﬂ ash. When ﬂ ashing you can adjust to the desired temperature

setting. If you hold these buttons down the values will rapidly increase or decrease. The new

and desired temperature setting will remain on the LED display for 5 seconds to conﬁ rm the new

value.

NOTE: The default temperature is 20°C (68°F).

NOTE: Temperature adjustment ranges from 20°C (68°F) to 40°C (104°F).

Water Filter Button:

This button turns the ﬁ lter pump on and off. If the heating system is activated the ﬁ ltration

system will automatically start.

The water ﬁ lter icon on the display is green when activated.

Bubble Button: Use this button to activate the massage system, which has a 30-minute

auto-shutoff feature. The bubble icon on the displays is green when activated.

WARNING: Do not run Bubble system when the cover is attached, air can accumulate

inside the spa and cause irreparable damage and bodily harm.

LED Display: Once plugged in the LED displays the current water temperature automatically.

NOTE: the built-in hard water treatment function works automatically in conjunction with the ﬁ ltration system.

IMPORTANT: The following conditions will lead to slow water heating.

• The ambient temperature is lower than 10ºC (50ºF).

• Outdoor wind speed is above 3.5-5.4m/s (8-12 mph).

• The air bubble function is activated when heating the spa water.

• The spa is not properly covered with the spa cover when the water is heating.

A: Heat Button

B: Celsius/Fahrenheit Toggle Button

C: Temperature Increase Button

D: Temperature Decrease Button

E: Water Filter Button

F: Bubble Button

G: LED Display

H: On/Off Button

40 C

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex PureSpa - 28404GN Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Intex PureSpa - 28404GN

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info