Bedienungsanleitung Intex PureSpa SJB-HS-33-1G (Seite 13 von 29) (Englisch)

686583

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

299

NLA

S AVE THESE INSTRUCTIONS

(299NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 05/10/2017

English

Page 13

The spa comes with a built-in saltwater sanitation system. Common salt (sodium chloride) is

made up of two elements, sodium and chloride. During the installation of the device, a

measured quantity of salt is dissolved in the SPA water to make it slightly salty. The SPA water

ﬂ ows through the sanitation system’s electrolytic cell to produce chlorine. The chlorine dissolves

in the water and instantly starts destroying bacteria and algae. It also oxidizes all other organic

materials.

• Which kind of salt to use:

Use only Sodium Chloride Salts

Use only sodium chloride (NaCl) salt that is at least 99.9% pure. It is also acceptable to use water

conditioning salt pellets (the compressed forms of evaporated salt). However, it will take a longer

time for them to dissolve. Do not use iodized or yellow (yellow prussiate of soda) colored

salt. Salt is added to the SPA water and the electrolytic cell uses the salt to create chlorine. The

purer the salt the better the performance of the electrolytic cell.

• Optimum Salt Levels

The ideal salt level in the SPA water is between 2000-3000 ppm (parts per million). The optimal

level is 2500 ppm.

A too low salt level will reduce the efﬁ ciency of the sanitation system and result in low chlorine

production. Too high a salt level may damage the power supply and cause corrosion to metal

ﬁ xtures and accessories. The salt in the SPA is constantly recycled. The loss of salt is due only to

SPA water being physically removed from the SPA. Salt is not lost due to evaporation.

• Adding Salt

1. Switch the JET pump on to start the water circulation.

2. Keep the sanitation system turned off.

3. Evenly spread 4.4 lbs / 2 kg (for 4 adults’) of salt around the inside perimeter of the SPA. For

six adults’: 5.5 lbs / 2.5 kg of salt.

4. Brush the SPA bottom to speed up the dissolving process. Do not allow salt to pile up on the

bottom of the SPA. Run the JET pump for one hour to thoroughly dissolve the salt.

5. When all the salt is dissolved, press the sanitizer button to activate the sanitation system

(see “Sanitation System Operating Instructions” section), code “003H” is ﬂ ashing and set the

sanitation system to desired operating hours. NOTE: DO NOT press any other buttons on the

control panel, and attach the spa cover during the sanitizing process.

• Removing Salt if Salt Level is too high

If too much salt has been added, the unit will beep and display “E92” (see “LED Code Chart”). If

this happens, turn off the sanitation system by pressing the ON/OFF button , and unplug the

spa. You will need to lower the salt concentration. The only way to do so is to partially drain the

SPA and reﬁ ll it with fresh water. Drain and reﬁ ll approximately 25% of the SPA water until the “E92”

alarm code disappears.

• Adding Salt if Salt Level is too low

If not enough salt has been added, the unit will beep and display “E91” (see “LED Code Chart”).

If this happens, turn off the sanitation system by pressing the ON/OFF button , unplug the

spa and wait 10 seconds. Plug and turn on the spa, add 1.1 lbs / 0.5 kg increment of salt until the

“E91” alarm code disappears (see “Adding Salt” section).

SALT LEVEL INFORMATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex PureSpa SJB-HS-33-1G Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Intex PureSpa SJB-HS-33-1G

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info