752503
11
Zoom out
Zoom in
Vorherige Seite
1/18
Nächste Seite
120A
SAVE THESE INSTRUCTIONS
(120IO) SEQUOIA SPIRIT™ WOOD-GRAIN FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/16/2014
English
Page 11
POOL ENCLOSURE SETUP
Once the pool has been filled with water, and it has been confirmed that it is completely level and that all
vertical legs are positioned in the middle of each patio block, proceed with the assembly of the pool
enclosure.
1. Top clamp installation
Fasten a top clamp (16) to the T-joint of the pool frame from the underneath. Ensure the two bolts on
top clamp are facing upward. Repeat the procedure until all the top clamps are fastened to the T joints
of the pool frame (see drawings 8.1 & 8.2).
2. Bottom cap and bottom rail installation
Place a bottom cap (25) on the ground and align it with the leg cap. Ensure that the threaded side hole
in the bottom cap is facing outward. Place all bottom caps in position.
Starting at any location, but always working in the same direction, connect a bottom rail (24) in between
two bottom caps (25). Ensure the pre-drilled holes on the bottom rail hook through the knobs on the
bottom cap. Repeat this procedure in a circular fashion until all the bottom rails and bottom caps have
been connected. Adjust the distance of the bottom cap to the leg cap by estimating that the support
post
(17) will stand vertical after it is installed (see drawings 9.1 & 9.2).
3. Support post installation
Remove the cardboard inserts from the both slides of each support post.
Insert the support post (17) into the bottom cap (25). Lift up the support post slightly to let the slot on
the upper end of the support post hook onto the ridge at the top clamp. Push downward to ensure the
support post is connected firmly with the top clamp and inserted in the bottom cap (see drawings 10.1,
10.2 & 10.3).
Repeat these procedures until all the support posts are joined to the top clamps and bottom caps (see
drawing 10.4).
8.1 8.2
9.1 9.2
10.1 10.2
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Intex Sequoia Spirit wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Intex Sequoia Spirit

Intex Sequoia Spirit Bedienungsanleitung - Deutsch - 18 seiten

Intex Sequoia Spirit Bedienungsanleitung - Holländisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info