Bedienungsanleitung Intex SF80110-2 (Seite 22 von 24) (Englisch)

752308

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

342

SAVE THESE INSTRUCTIONS

(342PO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/08/2018

English

Page 22

COMMON POOL PROBLEMS

PROBLEM DESCRIPTION CAUSE SOLUTION

ALGAE

COLORED

WATER

FLOATING

MATTER IN

WATER

CHRONIC

LOW WATER

LEVEL

SEDIMENT

ON POOL

BOTTOM

SURFACE

DEBRIS

• Chlorine and pH levels need

adjustment.

• Copper, iron or maganese

in water being oxidized by

the added chlorine.

• "Hard water" caused by

a too high pH level.

• Chlorine content is low.

• Foreign matter in water.

• Rip or hole in pool liner or

hoses.

• The drain valves are loose.

• Heavy use, getting in and

out of pool.

• Pool too close to trees.

• Super chlorinate with shock

treatment. Correct pH to your

pool store's recommended

level.

• Vacuum pool bottom.

• Maintain proper chlorine

level.

• Adjust pH level to the

recommended level.

• Run filter until water is clear.

• Correct the pH level. Check

with your pool dealer for

advice.

• Adjust the chlorine level.

• Repair with a patch kit.

• Finger tighten all caps.

• Use Intex pool vacuum to

clean bottom of pool.

• Use Intex pool skimmer.

• Greenish water.

• Green or black spots

on pool liner.

• Pool liner is slippery

and/or has a bad odor.

• Water turns blue, brown,

or black when first

treated with chlorine.

• Water is cloudy or milky.

• Level is lower than on

previous day.

• Dirt or sand on pool floor.

• Leaves, insects etc.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

IMPORTANT

If you continue to experience difficulty, please contact our Consumer Service Department

for assistance. See separate “Authorized Service Centers” sheet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex SF80110-2 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info