Bedienungsanleitung Inventor V6MKI32-WiFi (Seite 32 von 140) (Deutsch, Englisch)

771741

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

◄ Page 32 ►

• the charge size is in accordance with the room size within which the refrigerant containing parts are

installed;

• the ventilation machinery and outlets are operating adequately and are not obstructed;

• if an indirect refrigerating circuit is being used, the secondary circuits shall be checked for the pres-

ence of refrigerant; marking to the equipment continues to be visible and legible.

• marking and signs that are illegible shall be corrected;

• refrigeration pipe or components are installed in a position where they are unlikely to be exposed

to any substance which may corrode refrigerant containing components, unless

• the components are constructed of materials which are inherently resistant to being

• corroded or are suitably protected against being so corroded.

9. Checks to electrical devices

Repair and maintenance to electrical components shall include initial safety checks and component

inspection procedures. If a fault exists that could compromise safety, then no electrical supply shall be

connected to the circuit until it is satisfactorily dealt with. If the fault cannot be corrected immediately

but it is necessary to continue operation, and adequate temporary solution shall be used. This shall be

reported to the owner of the equipment so all parties are advised.

Initial safety checks shall include:

• that capacitors are discharged: this shall be done in a safe manner to avoid possibility of sparking

• that there no live electrical components and wiring are exposed while charging, recovering or purg-

ing the system;

• that there is continuity of earth bonding.

10. Repairs to sealed components

10.1 During repairs to sealed components, all electrical supplies shall be disconnected from the equip-

ment being worked upon prior to any removal of sealed covers, etc. If it is absolutely necessary to

have an electrical supply to equipment during servicing, then a permanently operating form of leak

detection shall be located at the most critical point to warn of a potentially hazardous situation.

10.2 Particular attention shall be paid to the following to ensure that by working on electrical com-

ponents, the casing is not altered in such a way that the level of protection is affected. This shall

include damage to cables, excessive number of connections, terminals not made to original specifi-

cation, damage to seals, incorrect fitting of glands, etc.

• Ensure that apparatus is mounted securely.

• Ensure that seals or sealing materials have not degraded such that they no longer serve the pur-

pose of preventing the ingress of flammable atmospheres. Replacement parts shall be in accor-

dance with the manufacturer’s specifications.

NOTE: The use of silicon sealant may inhibit the effectiveness of some types of leak detection equip-

ment. Instrinsically safe components do not have to be isolated prior to working on them.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventor V6MKI32-WiFi Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Inventor V6MKI32-WiFi

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info