Bedienungsanleitung Inventum AC907W (Seite 42 von 100) (Deutsch, Englisch, Holländisch, Französisch)

790072

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Caution:

• Condensation water may run out of the drain when the screw cap is

removed and the appliance has been used in cooling mode.

Keep a drip tray at hand when removing the screw cap, in order to

collect the condensation water.

• Make sure the discharge hose for the condensation water properly

descends and is not higher than the drain of the appliance.

• When using the cooling position, it is recommended to not

discharge the condensation water continuously, but to close

the screw cap again. In this way the appliance is able to provide its best performance.

AIR CIRCULATION

When using this position, the air discharge hose does not have to be connected.

• Press the [ ] key until the indicator light - air circulation - lights up.

• Press the [ ] key to set the wind speed to - high, medium or low.

This is indicated on the display as follows: high speed, medium speed, low speed.

AUTOMATIC POSITION

When using the automatic position, the appliance automatically selects whether it should cool or circulate air. This depends

on the room temperature.

• Press the [ mode / ] key until the indicator light - auto - lights up. The display shows the following:

• It is possible to adjust the wind speed. Press the [ speed / ] key to select the required wind speed.

When the room temperature is below 23°C, the appliance starts to circulate the air, and above 23°C the appliance starts to cool.

ADJUSTING THE TIMER -

The timer function can be used to allow the appliance to switch on automatically (delayed start) or switch off automatically

at a set time (automatic deactivation).

Delayed start

• Switch on the appliance and select the position you want to use.

• Switch off the appliance. The appliance remembers the last setting and will switch on at that position/temperature.

• Press the timer key when the appliance is off and the screen will display 1-24 hours.

• Press the timer key several times until the desired time is displayed. Wait 5 seconds until the timer is conﬁrmed. The

indicator light of the timer lights up and the timer symbol is shown in the display.

• When the set number of hours have passed, the appliance switches on automatically.

To cancel the delayed start, press the timer key once more or press the ON/OFF key .

Automatic deactivation

• Press the timer key when the appliance is on. The display will show hours.

• Press the timer key several times until the desired time is displayed. Wait 5 seconds until the timer is conﬁrmed. The

indicator light of the timer lights up and the timer symbol is shown in the display.

• When the set number of hours have passed, the appliance switches off automatically.

To cancel the automatic deactivation, press the timer key once more or press the ON/OFF key .

42 • English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum AC907W Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info