Bedienungsanleitung Inventum AKM9004RVS (Seite 21 von 28) (Englisch, Holländisch)

704929

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

controls

cleaning & maintenance

Before performing any maintenance operation, disconnect the cooker hood from the mains power supply. Ensure that it is

switched off and pull the plug or remove the connector fuse.

Clean the in- and outside of the cooker hood regularly. Clean the cooker hood with warm soapy water and a soft cloth. If your model

is stainless steel, clean it with a stainless steel care product. Do not use any abrasive cleaning agents such as powder cleaners or

cleaners that contain alcohol. Clean the controls only with a damp cloth.

Attention: failure to carry out the basic cleaning recommendations can cause ﬁre risks.

GREASE FILTERS

A metal grease ﬁlter ﬁlters the fat particles in the air. Therefore the ﬁlter can get clogged, depending on the use. The metal grease ﬁlter

does not have to be replaced, but should at least be cleaned once a month. You can clean it either by hand or in the dishwasher on a

low temperature. Make sure the grease ﬁlters are competely dry before placing them back.

Do not use any abrasive cleaning agents.

Not cleaning the grease ﬁlters on time can cause ﬁre risks.

Cleaning the grease ﬁlters in the dishwasher can cause discoloration. This has no effect on the operation.

REMOVING THE GREASE FILTER

Switch off the electricity! Remove the plug from the socket.

Pull the grease ﬁlter towards you and tilt it downwards at the front. Make sure

you guide the grease ﬁlter with you other hand to prevent the grease ﬁlter

from falling down on your cooking appliance.

CHANGING A LED SPOT

When a LED spot of the cooker hood is broken, you can replace it yourself. Follow these steps:

• Unplug the appliance or remove the connector fuse.

• Remove the grease ﬁlters and push the complete spot from the inside downwards - ﬁgure 1.

• Unplug the broken LED from the transformer - ﬁgure 2. Replace the complete LED with a matching type (3.0 W, LED L27A).

• Plug the new LED in the transformer and push the complete spot back in the housing of the cooker hood.

• Replace the grease ﬁlters and plug the appliance in.

English • 21

OPENING AND SHUTTING THE ELECTRIC VALVE

• Press to open the electric valve. The backlight from the buttons will light up when the electric valve is open and the cooker hood

is activated.

Press the same button to shut the electric valve. The backlight from the buttons will go out.

• Press and the lighting switches on. Press the button again to switch the lighting off.

Switch the lighting on if you need more light on your cooking appliance. It is recommended to open the valve a few minutes prior to

cooking. Leave the valve open for 5 to 10 minutes after the cooking is ﬁnished to remove all the smells from the kitchen.

1 2

3W LED

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum AKM9004RVS Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info