Bedienungsanleitung Inventum AKP90 (Seite 19 von 48) (Deutsch, Englisch, Holländisch, Französisch)

705004

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

controls

cleaning & maintenance

Before performing any maintenance operation, disconnect the cooker hood from the mains power supply. Ensure that it is

switched off and pull the plug or remove the connector fuse.

Clean the in- and outside of the cooker hood regularly. Clean the cooker hood with warm soapy water and a soft cloth. If your model

is stainless steel, clean it with a stainless steel care product. Do not use any abrasive cleaning agents such as powder cleaners or

cleaners that contain alcohol. Clean the controls only with a damp cloth.

Attention: failure to carry out the basic cleaning recommendations can cause ﬁre risks.

GREASE FILTERS

A metal grease ﬁlter ﬁlters the fat particles in the air. Therefore the ﬁlter can get clogged, depending on the use. The metal grease ﬁlter

does not have to be replaced, but should at least be cleaned once a month. You can clean it either by hand or in the dishwasher on a

low temperature. Make sure the grease ﬁlters are competely dry before placing them back.

Do not use any abrasive cleaning agents.

Not cleaning the grease ﬁlters on time can cause ﬁre risks.

Cleaning the grease ﬁlters in the dishwasher can cause discoloration. This has no effect on the operation.

REMOVING THE GREASE FILTER

Switch off the electricity! Remove the plug from the socket.

Pull the grease ﬁlter towards you and tilt it downwards at the front. Make sure you guide

the grease ﬁlter with you other hand to prevent the grease ﬁlter from falling down on

your cooking appliance.

REPLACING THE CARBON FILTERS

A carbon ﬁlter cleans the air and ﬁlters the smell that occurs during cooking. A carbon ﬁlter can not be washed and reused. In all cases

it is necessary to replace the carbon ﬁlter at least every four months.

• Remove the grease ﬁlters.

• Attach two carbon ﬁlters to the motor.

• Replace the grease ﬁlters.

REPLACING THE LED LIGHTING

This appliance is equipped with a LED light. It can be used for a long time. In case, the LED light is blown, it must be replaced by a

qualiﬁed person to avoid any hazard. Contact the Inventum service department.

SWITCHING THE COOKER HOOD ON AND OFF

• Press 0 to turn the motor off.

• Press 1 and the motor runs at the lowest speed.

• Press 2 and the motor runs at the middle speed.

• Press 3 and the motor runs at the highest speed.

• Press

and the lighting switches on. Press the button again to switch the lighting off.

Switch the lighting on if you need more light on your cooking appliance. It is recommended to operate the appliance a few minutes

prior to cooking. Leave the appliance in operation for 5 to 10 minutes after the cooking is ﬁnished to remove all the smells from the

kitchen.

English • 19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum AKP90 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info