Bedienungsanleitung Inventum HS422CG (Seite 10 von 24) (Deutsch, Englisch, Holländisch, Französisch)

616168

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Before you use the appliance for the ﬁrst time, please do

as follows: Unpack the appliance carefully and remove all

the packaging material. Keep the material (plastic bags and

cardboard) out of reach of children.

Check the appliance after unpacking for any visible damage, that

could be caused by transportation. Do not use the appliance if

there are visible signs of damage.

When using the iron for the ﬁrst time, you may notice a slight

emission of smoke and hear some sounds made by the

expanding plastics. This is quite normal and it stops after a short

time.

appliance description

before the ﬁrst use

steam ironing

10 • English

Sort the laundry to be ironed according to the international

symbols on the garment label, or if this is missing, according to

the type of fabric.

Garment

label

Type of fabric Temperature setting

synthetic

•

low temperature

silk - wool

••

medium temperature

coton - linen

•••

high temperature

do not iron

Start ironing the garments requiring a low temperature.

This reduces the waiting times (the iron takes less time to heat

up than to cool down) and eliminates the risk of scorching the

fabric.

Check that the plug is disconnected from

the socket.

Move the steam selector to

Open the lid and slowly pour the water into

the reservoir using the special measure

cup. Take care not to go over the maximum

level (about 260 ml) indicated by MAX on

the reservoir.

Close the lid.

ﬁlling the reservoir

selecting the temperature

Put the iron in a vertical position and put the plug in the socket.

Adjust the temperature knob according to the international

symbol on the garment label.

The control light indicates that the iron is heating up. Wait until

the control light goes off before ironing.

Warning: during ironing, the control light comes on at intervals,

indicating that the selected temperature is maintained. If

you lower the thermostat temperature after ironing at a high

temperature, do not start ironing until the control light comes

on again.

selecting the quantity of steam

The quantity of steam is regulated by the steam selector.

Move the steam selector to a position between minimum and

maximum depending on the quantity of steam required and the

temperature selected.

Warning: the iron gives off steam continuously only if you hold

the iron horizontally. You can stop the continuous steam by

placing the iron in a vertical position or by moving the steam

selector to .

As indicated on the thermostat knob and in the initial table, you

can only use steam at the highest temperatures. If the selected

temperature is too low, water may drip from the plate.

1. Lid

2. Steam selector

3. Shot steam button

4. Spray button

5. Handle

6. Control light

7. Temperature

8. Water reservoir

9. Self clean button

10. Plate

Cup

3 6 5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum HS422CG Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info