Bedienungsanleitung Inventum HW74B (Seite 14 von 20) (Deutsch, Englisch, Holländisch, Französisch)

54883

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Before plugging into a socket, check that the voltage in

your home corresponds with the voltage printed on the

bottom of the appliance. Put the appliance on a cool, at

and stable surface. Connect the appliance to an earthed

socket. You can adjust the length of the cord by pulling it

out from, or pushing it into, the interior of the appliance.

1. Open the lid by pushing the button.

2. Fill the kettle with an amount of water and close the

lid by pushing it down.

3. Place the kettle on the base and make sure that the

plug is in the socket.

4. Switch the kettle on by pressing the on/off switch

down to position 1.

The red pilot lamp will light up. The kettle will now

boil the water.

5. The kettle will automatically switch off when the water

is boiled.

The pilot lamp will switch off.

If you want to boil the water again, you must wait

approx. 30 seconds before you switch it on again, so

that the switch can cool down. The kettle can also be

switched off at any time with the switch. When you take

the waterkettle off the base while boiling, it will switch

off. When you place the waterkettle back on the base the

water will continue boiling. If that is not necessary, switch

the kettle of by pushing the switch to position 0.

Attention! Never switch the kettle on without water.

If, for whatever reason, the kettle is switched on without

water, the dry-boilprotection will automatically switch

the kettle off. Put the switch back to "0". In this case take

the kettle off the base and let it cool down for several

minutes. After that, rell the kettle and switch it on

again. Make sure that the lid is closed properly, if not the

kettle will go on boiling and will not automatically switch

off.

Attention! It may occur that you see condensation on the

base. This is completely normal and has no consequences

for the use of the waterkettle.

Before you use the appliance for the rst time, please do

as follows: Carefully unpack the appliance and remove

all the packaging material. Keep the material (plastic

bags and cardboard) out of reach of children. Check the

appliance after unpacking for any damage, possible from

transportation. Before plugging into a socket, check that

the voltage in your home corresponds with the voltage

printed on the bottom of the appliance. Put the appliance

on a at, stable and heat resistant surface.

Before use you must ll the waterkettle to the maximum

level and boil this amount. Do this twice. Throw away the

boiled water and rinse the kettle with cold water. The

appliance is now ready to use. The kettle is only suitable

for boiling water. Never

ll the kettle with milk, tea,

coffee or other drinks. The minimum amount of water

must be 0,5 liters. The maximum amount of water to be

used is 1,7 liters.

2 | BEFORE FIRST USE 3 | BOILING WATER

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum HW74B Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info