Bedienungsanleitung Inventum IKV0821D (Seite 28 von 40) (Englisch, Holländisch)

663671

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

troubleshooting

If your appliance is not working properly, it may be a minor problem, therefore check the following:

Problem Cause Solution

Appliance is not functioning; light

does not work

- Appliance is not plugged in

- There is a power failure

- The thermostat is set on ●

- Plug the appliance in

- Check the fuse box

- Set the thermostat on setting 1-5

Temperature inside the

appliance is too high or too low

Thermostat has been set

incorrectly

Set the thermostat correctly

Air circulation vents are blocked Clean the ventilation openings

Water is running out of the

appliance

Drain outlet is blocked Clear the drain outlet with a skewer

Appliance is excessively noisy Has the appliance been installed

correctly?

Check the installation

Are the pipes at the back touch-

ing or vibrating?

Check it and move the appliance forwards

The inside light is not working Lamp is defective Replace the bulb following the instructions

Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.

installation instructions

Before installation, read the instructions carefully.

• Fit the appliance only in stable kitchen units.

• If necessary, reverse the door according to the instructions.

• Check built in dimensions of your model according to the dimensions in ﬁgure A.

1 Remove the screw

on the top of the appliance, place the top bracket

and ﬁx the bracket with the screw

(Figure B).

2 Take out the gasket

located on the side panel and remove the protective tape. Stick the gasket on the reverse side of the door

hinges of the appliance (Figure C).

3 The height of the appliance can be adjusted with the adjustable feet to ﬁt the height of the cabinet (Figure D).

4 Slide the appliance into the kitchen cabinet and align the hinge surface with the front surface of the kitchen cabinet (Figure E).

5 Screw the hinges and metal bracket to the kitchen cabinet using the screws

(Figure F).

6 Unscrew and remove the nuts and washers from the appliance door. Place the door hang on the appliance door by inserting

the holes to adjustment bolts (Figure G).

Dimension B = measure from the underside surface of kitchen cabinet to the bottom of the door hang.

Dimension C = measure from the underside surface of the kitchen cabinet to the top of the next cabinet door.

7 Substract C from B and place the door hang

using this dimension for the vertical position and place to the center of the horizontal

position. Screw the door hang

using the screws

(Figure H).

8 Place the cabinet door onto the appliance door by inserting the adjustment bolts into the slots on the door hang. Place the washers

and screw the nuts onto the adjustment bolts (Figure I).

9 Close the door and check the alignment with the other cabinet doors. Make the adjustment of the unit door by screwing or

unscrewing the adjustment bolts for vertical adjustment and with the aid of the slots on the door hang for other directions. Tighten

the nuts to ﬁx the bracket (Figure J).

10 Remove the screws at the bottom of the appliance door. Place the door bottom ﬁxings

and screw the ﬁxings to the appliance door

and the cabinet door (Figure K).

11 Slide the hang cover

onto the door hang (Figure L).

12 Position the plinth providing a gap with a minimum of 25 mm between the cabinet door and ﬁx it (Figure M).

28 • English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum IKV0821D Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Inventum IKV0821D

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info