Bedienungsanleitung Inventum IVW6010A (Seite 46 von 56) (Englisch, Holländisch)

639701

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

46 • English

• The safety during use can only be guaranteed when the appliance is installed correctly and according to the regulations. The

installer is responsible for any damage caused by a faulty installation.

• The electrical connection must be made by a qualiﬁed electricien. This person is aware of the national and local regulations the

installation must comply with.

• The appliance can only be used in combination with a grounding conductor connection. The manufacturer accepts no

responsibility for any malfunction or damage caused by incorrect electrical installations.

• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. If there is an oven installed below,

pass the cable along the rear corners of the oven to the connection box. It must be positioned so that it does not touch any of the

hot parts of the hob or the oven.

• The connection point, the wall socket and/or plug must always be accessible.

• Damage caused by incorrect connection, incorrect use or incorrect ﬁtting is not covered by the guarantee.

• Attention: any change to the appliance’s interior, including ﬁtting and changing the power cable, must only be performed by a

qualiﬁed electricien.

1. Install the dishwasher at the desired location taking into account the length of the inlet and drain hoses and the power cord. Also

check the installation instructions on the accompanying installation template. Preparations should be made before placing the

dishwasher at it's ﬁnal location. Choose, if necessary, one side of the cabinet to facilitate the connection of drain hoses of the

dishwasher - ﬁgure 1.

2. If the dishwasher is installed in the corner of the cabinet, there should be some space left when the door is opened - ﬁgure 2.

3. The aesthetic wooden panel can be ﬁxed on the outer door according to ﬁgure 3.

4. Install the hook on the aesthetic wooden panel and put the hook into the slot of the outer door of the dishwasher - ﬁgure 4a. After

positioning the panel, ﬁx the panel onto the outer door with the screws and bolts - ﬁgure 4b.

5. The door springs are set at the factory to the proper tension for the outer door. When the aesthetic wooden panel is placed, you

will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable -

ﬁgure 5. The door spring tension is correct when the door remains horizontal in the fully opened position yet rises to a close with

the slight lift of a ﬁnger.

installation instructions

90 90

820 mm

580 mm

100

600 mm

Electrical, drain and

water supply line

entrances

Space between cabinet

bottom and oor

DishwasherDishwasher

Door of

dishwasher

Cabinet

Minimum space of 50 mm

Cabinet dimensions less

than 5 mm between the

top of the dishwasher and

cabinet and the oudter

door must be aligned to

the cabinet.

Minimum space when the

door is opened.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum IVW6010A Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Inventum IVW6010A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info