Bedienungsanleitung Inventum KP602 (Seite 13 von 28) (Deutsch, Englisch, Holländisch, Französisch)

694974

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Before using the appliance for the ﬁrst time, you should proceed as follows: carefully unpack the hob and remove all packaging

material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children.

Afterunpacking the appliance, check it for external damage that may have occurred during transport.

Place the hot plate on a sturdy, ﬂat and heat-resistant surface. Clean the hot plate with a slightly damp cloth. The cook plate(s)

is/are provided with a protective layer that must be removed prior to ﬁrst use. This is done by turning on the cook plate

atmaximum level for approximately 4 to 5 minutes. Light smoke may form due to the protective layer burning off the cook plate.

After removing the protective layer you can switch off the cook plate or start using it.

Make sure the thermostat button is on the «OFF» position before the appliance is switched on. Insert the plug in the socket.

Turn the thermostat knob to the right, to the required position. The accompanying indicator led will light up.

Position «MIN» of the cook plate is the lowest position and position «MAX» is the highest position.

Use a low position [ MIN to 4 ] for simmering and a higher position [ 5 tot MAX ] for boiling and frying.

The thermostat button is a stepless control.

OFF = off

MIN = low

1-4 = keep warm-simmer

5 = boiling and frying

MAX = high

It takes approximately 10 minutes for the cook plate to reach maximum temperature (on the maximum setting of the thermostat knob).

When the temperature that belongs to the set position is reached, the indicator led switches off. After a drop in temperature,

heattransfer to the pan, the thermostat switches on again. The indicator led will light up again.

Due to the construction of the hot plate, it remains hot for some time after switching off. This residual heat can be used to keep

the food warm for a short period of time.

CAUTION: THE APPLIANCE CAN GET VERY HOT DURING USE, THEREFORE PLACE THE APPLIANCE DURING USE ON A HEAT-

RESISTANT PLATE AND NEVER, FOR EXAMPLE, ON A PLASTIC TABLE, PLASTIC TABLE CLOTH OR REFRIDGERATOR.

Only use pans with bottoms that have the same diameter as the hot plate itself. Smaller diameters lead to loss of energy.

Do not touch the hot plate when it is switched on. Please note that the hot plate does not cool down immediately after being

switched off. Turn the thermostat button to the «OFF» position to switch off the hot plate and after each use, remove the plug

from the socket.

prior to ﬁrst use

use

Prior to cleaning, always switch off the appliance and remove the plug from the wall socket. Allow the hot plate to cool down

before cleaning it with a damp cloth.

The base unit can also be cleaned with a damp cloth or sponge. Do not use abrasives or other aggressive cleaning agents.

Do remember that the hot plates require some time to cool down after having been switched off.

Do not submerge the appliance in water and/or other liquids.

cleaning and maintenance

English • 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum KP602 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info