Bedienungsanleitung Inventum MK500 (Seite 10 von 24) (Deutsch, Englisch, Holländisch, Französisch)

551622

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

appliance description

10 • English

before ﬁrst use

preparing milk foam

heating milk

1. Lid with sealing ring

2. Silicone cuff

3. Start button for heating and frothing

4.Start button for just frothing

5. Base

6. Maximum indication for heating milk - MAX

7. Maximum indication for frothing milk - MAX

8. Whisk (frothing)

9. Mixer (heating)

8 9

Before you use the appliance for the first time, please do

as follows: Carefully unpack the appliance and remove all

the packaging material. Keep the material (plastic bags and

cardboard) out of reach of children. Check the appliance after

unpacking for any visible damage, possible from transportation.

Place the appliance on a stable and heat resistant surface.

Clean the lid, the whisk and the mixer with warm soapy

water. Dry the parts thoroughly. Make sure that the parts are

completely dry.

Wipe the exterior and interior with a soft damp cloth and dry

thoroughly. The appliance is only suitable heating and frothing

milk. Never fill the appliance with other drinks.

Check that the voltage in your home corresponds with the

voltage printed on the bottom of the appliance and plug

the appliance in.

Lift the lid and fit the whisk in the jug. Fill the desired amount of

milk into the jug. Do not exceed the maximum of the lower max.

mark - MAX

- 80 ml. Frothed milk expands and causes the

pitcher to overflow, if filled up too high. The minimum capacity

is 50 ml.

Put the lid back on the jug and place the appliance on the

base. Start the preparation by pushing one of the buttons

- heating and frothing or

- just frothing. The control light will

burn and the whisk will start turning. Depending on the filling

volume, the preparation stops automatically after 65 to 90

seconds. The control light goes out. After the preparation is

completed, remove the lid upwards and pour or ladle the milk

foam into a cup or bowl.

Do not remove the foam with a spoon or other metal object.

This will damage the coating.

After having used the frother, clean the appliance as described

in the chapter Cleaning & Maintenance.

Allow the appliance to cool down for 2 to 4 minutes before using

it again.

TIPPS

• The best result is achievement when using whole milk.

• If the amount of milk of too low the result will not be good -

less than 50 ml.

Lift the lid and fit the mixer in the jug. Fill the desired amount of

milk into the jug. Do not exceed the maximum of the top max.

mark - MAX

- 200 ml.

Put the lid back on the jug and place the appliance on the base.

Start the preparation by pushing the start button . The

control light will burn and the mixer will start turning. Depending

on the filling volume, the preparation stops automatically after

120 to 140 seconds. The control light goes out.

After the preparation is completed, remove the lid upwards and

pour the hot milk into a cup.After having used the appliance,

clean it as described in the chapter Cleaning & Maintenance.

Allow the appliance to cool down for 2 to 4 minutes before using

it again.

MK450-500-instructions.indd 10 27-8-2014 12:12:19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum MK500 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info