Bedienungsanleitung Inventum NB450 (Seite 13 von 32) (Deutsch, Englisch, Holländisch, Französisch)

694949

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

using the mixer

English • 13

cleaning & maintenance

Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the

appliance.

1. Place the mixer on a ﬂat, clean and dry surface.

2. Make sure that the mixer is not activated.

3. Place the ingredients in the jug and lock it with the lid. Place the jug with the handle on the right side onto

the base and turn it clockwise, until you feel it click into place.

4. Activate the mixer by choosing a speed setting.

Attention: Do not activate the mixer constantly, this can cause engine problems. Do not use the mixer for

more then 1 minute continuously, wait 1 minute before you operate it again.

5. When the mixer has ﬁnished mixing, blending or crushing turn the control button OFF (0) and wait until

the knives have stopped turning, before you remove the jug.

tips

• When the jug is cracked, do not use the mixer anymore. This could lead to damage while using the mixer.

• To avoid splashes always place the lid on the jug.

• Always add liquid ingredients before adding solid ingredients in the mixer.

• The mixer mixes best when you do not add pieces which are too large.

• Always add a half a cup of liquids when you crush ice cubes.

• To add ingredients while the mixer is activated, take the cap out of the lid and add the ingredients through the opening.

• When the ingredients stick to the sides of the jug or are not mixed properly, shut off the engine: wait until the knives have stopped

turning and push the ingredients with a spatula towards the knives.

• To prevent the ingredients from being blend to small, take into account that the mixer mixes in seconds, not minutes!

• Working with warm ingredients can cause a build-up of pressure in the jug and that can cause hot liquids to escape when you take

the lid of the jug. Therefore always remove the cap from the lid when you are processing warm ingredients.

Always unplug the cord from the socket before cleaning the appliance.

• Wipe the base with a damp cloth. Do not use any abrasive or strong detergents.

• Never place the appliance, the power cable or the plug in water or any other liquid.

• Remove the knives according to the instructions below. Be careful, the knives are extremely sharp. Clean the knives as a whole do

not try to take them apart. Attention: do not use any abrasive or strong detergents.

• For placing and removing the knives you need the glass jug and the knives. Place the glass jug, without the lid, upside down on a ﬂat

stable surface. Put your thumb and foreﬁnger in the middle plastic ring and loosen it clockwise. Now take the knive assembly and

the silicone ring out of the blender. Attention: never try to take the knive assembly apart.

To replace the knives follow the instructions in the reverse order. Make sure not to forget to place the silicone ring. The blender will

leak without the silicone ring.

• The following parts can be cleaned: the jug, the knive assembly, the lid and the cap. Be careful when cleaning the knive assembly.

The knives are very sharp.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum NB450 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info