Bedienungsanleitung Inventum VFI6042 ZWA (Seite 39 von 56) (Englisch, Holländisch)

737419

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English • 39

AUTOMATIC OPERATION

Use this function if the oven is to be switched on for a speciﬁed period of time and switched off

at a ﬁxed hour.

Set the preparation time and the end time.

Example: the current time is 11:00. The cooking time is 1 hour. The dish has to be done by 14:00.

The oven starts cooking at 13:00 (14:00 minus 1 hour) on the preset temperature and oven

function and will ﬁnish at 14:00.

• Press the [ OK ] key until the display shows dur and the

symbol ﬂashes.

• Set the required preparation time using the keys [ < ] or [ > ].

• Press the [ OK ] key repeatedly until the display shows End and the symbol ﬂashes.

• Set the switch off time (preparation end time) using the keys [ < ] or [ > ]. The end time is

limited to a period of 23 hours and 59 minutes.

• Set the oven function knob and the temperature knob to the setting at which you want the

oven to operate. Both symbols and are now active. Automatic operation has been set

• Once the preparation time has elapsed the oven will turn off automatically. You will hear an

alarm and the symbols

and will be ﬂashing.

• Press and hold any key to mute the alarm. The symbols and will be off and the display

will show the current time after approximately 7 seconds - i.e. 14:02.

• Turn the knobs for the oven function and the temperature to the off setting [ 0 /



CANCEL SETTINGS

The timer and the automatic function settings may be cancelled at any time.

• Press the keys [ < ] and [ > ] simultaneously to cancel the automatic function settings.

• Press the [ OK ] key to select the timer settings and then press the keys [ < ] and [ > ] simultaneously to cancel the timer.

CHANGE THE TONE OF THE ALARM SIGNAL

The tone of the alarm signal may be changed as follows:

• Press the keys [ < ] and [ > ] simultaneously.

• Select with the [ OK ] key the function ton. The display will ﬂash.

• Select with the key [ > ] the desired tone in the following order: ton 1, ton 2 or ton 3

• select with the key [ < ] the desired tone in the reverse order: ton 3, ton 2 or ton 1.

ADJUSTING THE BRIGHTNESS OF THE DISPLAY

You can adjust the brightness of the display in the range of 1 to 9, where 1 is the darkest and 9 is

the brightest. The brightness setting applies to an inactive control panel, i.e. when none of the

controls are used 7 seconds.

• Press the keys [ < ] and [ > ] simultaneously.

• Press the [ OK ] key repeatedly to select the bri setting. The settings can be accessed in

sequence ton (tone) and bri (brightness).

• Select the desired brightness with the key [ > ] in the following order: 1 to 9

• select the desired brightness with the key [ < ] in the reverse order: 9 to 1.

Note: The display is at its brightest setting when active, i.e. a control was touched within the last 7 seconds.

NIGHT MODE

The display is dimmed during the night hours: 22:00 - 6:00.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inventum VFI6042 ZWA Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Inventum VFI6042 ZWA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info