790020
39
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
English 39
LEVELLING THE APPLIANCE
Use a water level and spanners No. 32 (for feet) and 17 (for the nut).
1. Level the washing machine in longitudinal and traverse
direction byscrewing the adjustable feet up or down.
2. After adjusting the height of the feet, firmly tighten the jam
nuts (counter nuts) using a spanner No 17, by turning them
towards thebottom of the washing machine (see figure).
i
Incorrect levelling of the washing machine with the
adjustable legsmay cause vibration, appliance moving across
the room, and loud operation.
Incorrect levelling of the washing machine is not subject to
warranty.
Sometimes, an unusual or louder noise may appear during
appliance operation; these are mostly the result of improper installation.
CONNECTING THE WATER SUPPLY HOSE
WARNING! To prevent leakage or water damage, follow the instructions in this chapter. Make sure not to kink, crush or
modify the water supply hose.
Tighten the water supply hose by hand, firmly enough for the hose to have a good seal. After connecting the hose, the
seal must be checked for any leaks. Do not use pliers or similar tools when connecting the water supply hose as this could
damage the nut thread.
1. Connect the water supply hose to the water inlet valve on
the back ofthe appliance.
2. Connect the other end of the water supply hose with the
aqua stop toa water tap with cold water.
CONNECTING THE WATER DISCHARGE HOSE
WARNING!
Make sure not to kink or stretch the water discharge hose.
Connect the water discharge hose properly, otherwise it could result in damage or water leakage.
Feed the water discharge hose into a drain pipe, wash basin or floor drain. Be careful not to feed the water discharge hose
too deep in the drain. Otherwise the waste water cannot flow freely. The vertical distance from the floor to the end of the
discharge hose may be no more than 100 cm and no less than 60 cm.
1. Put the water discharge hose in a floor drain. 2. Connect the water discharge hose to a drain pipe.
Max. 100 cm
Min. 60 cm
Max. 100 cm
Min. 60 cm
Max. 100 cm
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Inventum VWM9001 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info