Bedienungsanleitung Inverto IDLV-4000P (Seite 13 von 38) (Englisch)

509862

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

Main menu Sub-menu Description

Inputs

Status Display the status of signal inputs for ASI, TUNER and IP IN:

ASI Input: Locked or unlock indicate the status of the ASI input.

Tuner Input: When the QPSK/QAM/COFDM signal is locked by the tuner, the

bit rate is displayed on the bottom row of LCD.

Ethernet: This indicates the status of the transport stream over IP input. The

bitrate is displayed on the bottom row of the LCD only if IP input is valid (note

this menu is showed only when the TS/IP streaming board is installed and the

board is set to “IP In”, refer to section Optional Function (External Board Type)

under System).

DVB-S2 This menu only is shown on IDLV-4000P-xxS2 model

LNB Frequency: Input LNB frequency

Satellite Frequency: Input downstream frequency of satellite

Symbol Rate: Input symbol rate of satellite

LNB Voltage: Select the correct LNB voltage output of the F-connector: Off, 13

V, 18 V. <13V for Vertical/Left hand polarization, 18V for Horizontal/Right hand,

OFF for LNB Power off.>

LNB 22KHz: activate the LNB 22 kHz control signal to the LNB: On or Off.

<22KHz control signal switches the LNB to receive high band if any>

DISQEC: Can select OFF/Port A/Port B/Port C/Port D

QPSK The same as DVB-S2

COFDM This menu only is shown on IDLV-4000P-xxT model

Frequency: Enter the proper frequency of the COFDM signal in MHz.

Bandwidth: Set the bandwidth from 6M/7M/8M

QAM This menu only is shown on IDLV-4000P-xxC model

Constellation: Enter the modulation mode of the QAM signal.

Frequency: Enter the frequency of the QAM signal in MHz.

Symbol Rate: Edit the symbol rate to the proper value in KBaud.

RSSI Display the quality of received DVB-S/S2 signal.

Ethernet This menu is part of the IDLV-4000P-44xx model, which sets TS/IP streaming

board as “IP IN”

Stream IP Addr: Enter the IP address for streaming IP input of the unit.

Stream Netmask: Enter the network sub mask for the subnet to which the unit

is connected for IP streaming trafc.

Stream Gateway: Set the gateway for the network to which the unit is con-

nected for IP streaming trafc.

Stream Mac Address: Factory-set MAC addresses are guaranteed to be

unique. Therefore you cannot congure the address.

Multicast IP Addr: Enter the IP address of the multicast stream for the trans-

port stream over IP.

Multicase UDP Port: Enter the UDP port number of the TS over IP stream.

Protocol: select the protocol for multicast: UDP or RTP.

Output Smoothing: Set the quality of TS which comes from the TS/IP input.

Auto: The bit rate is variable.

Disable: The unit let the TS pass by.

Fixed Rate: The bit rate is xed.

TS Bit Rate: Set the bit rate of the TS comes from the TS/IP input. The setting

is only valid when the output smoothing is congured as Fixed Rate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inverto IDLV-4000P Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info