Bedienungsanleitung Invicta Theia (Seite 21 von 44) (Englisch)

744560

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Energy Distribution 2015 21

of the paints and oils used when manufacturing the

woodstove. If you find it necessary, open a few

windows to vent your room. The smoke and fumes

will usually subside after 10 to 20 minutes of

operation. The odor and smoke will end once the

stove is “cured”.

The first few fires of the season may produce other

odors from impurities that exist in the area

immediately surrounding the stove. Some potential

impurities are cleaning solvents, paint solvents,

cigarette smoke, and soot from scented candles, pet

hair, dust, adhesives, a new carpet, and new textiles.

These odors will dissipate over time. You can

alleviate these odors by opening a few windows or

otherwise creating additional ventilation around your

stove. If any odor persists, contact your dealer or an

authorized service technician.

If you adhere to the operating procedures in this

manual, the steel and cast iron components of your

stove will give you many years of trouble-free use.

Avoid the following conditions that can cause the

glass, steel or cast iron pieces to break:

• Do not throw wood into the stove.

• Do not use the door as a lever to force wood into

the stove.

• Do not load wood encrusted with ice into a

burning stove - the thermal shock can cause

damage.

• Do not use a manufactured log grate or otherwise

support the fuel. Burn the fire directly on the floor

of the firebox.

BUILDING A BREAK IN FIRE

1) Open the front door and place five or six double

sheets of tightly twisted newspaper in the center

of the firebox. Arrange kindling in a crisscross

pattern over the newspaper. Kindling should be

approximately ten pieces, 1/2" (13 mm) in

diameter and 10" to 16" (254 mm to 457 mm)

long.

2) Light the paper under the kindling. Leave the

door slightly ajar momentarily until the kindling

has started to burn and draft begins to pull.

3) Close the door and allow the fire to burn. Keep

the door closed while the stove is in use.

4) KEEP A WATCHFUL EYE ON YOUR STOVE to

maintain a steady fire. Your first fire should make

the stove warm but not hot to the touch. Visible

steam, or boiling moisture and hissing indicate

the cast iron is too hot. At most, a few small

chunks of wood should be added to the fire to

reach safe break-in temperatures.

5) Once the stove is warm but not hot to the touch,

allow the fire to die out completely.

6) Let the stove return to room temperature.

Your first fire and first fire each season thereafter

should be built and maintained as outlined above.

Your patience will be rewarded by a properly

seasoned stove.

 NOTE : The cool flue gas temperatures present

during the break-in procedure may cause

rapid creosote build-up. The door glass may

also get dirty. A good hot fire will clean it. We

recommend a visual inspection (and cleaning

if necessary) of your stovepipe and chimney

once the break-in procedure is completed.

NORMAL OPERATION

BUILDING A FIRE FOR EVERYDAY USE

1) Open the front door and place five or six double

sheets of tightly twisted newspaper in the center

of the firebox. Arrange kindling in a tee-pee

configuration over the newspaper. Use

approximately 10 pieces of kindling, 1/2" (13 mm)

in diameter and 10" to 16" (254 mm to 406 mm)

long.

2) Light the paper under the kindling. Leave the front

door slightly ajar momentarily until the kindling

begins to burn and draft begins to pull (about 10

to 15 minutes).

3) Close the door and allow the fire to burn.

4) Once the kindling is burning, open the front door

and add logs, small at first, to build the fire up.

Ensure you keep the logs away from the glass in

front in order for the air-wash system to work

properly. Keep the front door closed while the

stove is in use.

CAUTION: DO NOT BUILD THE FIRE TOO CLOSE

TO THE GLASS. KEEPING THE FIRE TOWARDS

THE CENTER OF THE FIRE BOX WILL KEEP

COALS FROM BUILDING UP AGAINST THE

GLASS DURING RELOADING.

5) Once the fire is burning well, close the front door.

Now the combustion is steady and your stove will

be burning at its optimal efficiency.

Note: Always remember to use the cold handle

before opening the front door. When opening the front

door to reload or re-arrange logs, it is advisable to

open the door just a crack, pause for a moment then

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Invicta Theia Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info