Installation Instructions for Filter Cartridges
of GC, GCX and Dental Series Air Purifiers
Before the cartridges are unpacked from their individual wrapping,
it is recommended that working surfaces are covered because
loose carbon granuals may soil surfaces. Once unpacked, place the
cartridges on the table/floor with the opening facing downward
and pull a post-filter sleeve over each of the cartridges. With new
IQAir systems the sleeves are supplied inside of the IQAir System
(refer to steps 3, 4 and 5 below on how to open the IQAir System).
Cartridge shown with sleeve fitted. Ensure cartridge is completely
covered by post-filter sleeve.
12
105 03 00 22 / 1109
Pull the first locking arm outward to release the arm from its snap-
in position in the diffuser. Disengage the other arm the same way.
Pull both locking arms outwards evenly until they snap into place
and remain open.
Remove the diffuser and one top (GCX: top three) housing element.
If used cartridges are being replaced, also remove the frame element
containing the cartridges. Remove each cartridge by turning it
counterclockwise.
The slots on the metal plate should look as shown in the large
picture above.
Note: If you have an older IQAir system, the slot may look different
(see small picture above). In that case a set of cartridge adapter
rings is required to enable the insertion of new-style cartridges into
your IQAir system. These adapter rings can be obtained from your
point of purchase.
3
5
4
6
New-style slot
Old-style slots
(requires adapter ring)
