Bedienungsanleitung Irobot Roomba 860 (Seite 6 von 15) (Englisch)

667537

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Roomba

800 Series Owner’s Guide 3

Using your Roomba

• To send Roomba back to its Home Base during a cleaning cycle, press

DOCK on Roomba. This will end the cleaning cycle.

• To use SPOT Cleaning, place Roomba on top of the localised debris

and press SPOT on the robot. Roomba will thoroughly clean the area by

spiraling outward about 3 feet (1metre) in diameter and then spiraling

inward to where it started.

• When Roomba returns to the Home Base after completing a cleaning

cycle, it will play a series of tones to indicate successful completion of the

cleaning cycle.

Note: After each use, empty the bin and clean the ﬁlter.

• Always store Roomba on the Home Base so it’s charged and ready to

clean when you need it. If storing away from the Home Base, remove the

battery ﬁrst and then store Roomba and the battery in a cool, dry place.

Battery and Charging

Charge Roomba using the Home Base. The indicator lights will turn o

after 60 seconds to conserve energy while Roomba is charging. Check the

status of the battery by pressing the CLEAN button to illuminate the Battery

Indicator. The indicator will appear amber while the battery is charging and

solid green when fully charged.

Setting the Clock

You must set the clock before scheduling Roomba to clean. To set the time:

Positioning the Home Base

Place the Home Base in an open, uncluttered area,

leaving the following distances around the Home Base:

• At least 1.5 feet (0.5 metres) on each side of the

Home Base

• At least 4 feet (1.2 metres) in front of the Home

Base and at least 4 feet (1.2 metres) away from stairs

• At least 8 feet (2.4 metres) from Virtual Wall Barriers

Always keep the Home Base plugged in.

Use Instructions

• Turn your robot over and remove the bin insert and battery pull

tabs. Then place Roomba on the Home Base to charge.

• Fully charge the battery before the ﬁrst cleaning by allowing

Roomba to charge on the Home Base for 3 hours.

• Manually wake Roomba up by pressing CLEAN once.

To start a cleaning cycle, press CLEAN again.

Note: Remove excess clutter from ﬂoors before cleaning

(e.g. clothing, toys, etc.). Use Roomba frequently to maintain

well-conditioned ﬂoors.

• To pause Roomba during a cleaning cycle, press CLEAN. To

resume the cleaning cycle, press CLEAN again.

• To end the cleaning cycle and put Roomba in standby mode,

press and hold CLEAN until Roomba’s indicators turn o.

• If Roomba encounters an area of high debris concentration, it

will move in a forward/backward motion to clean the area more

thoroughly. When Roomba does this, you will see the Dirt Detect™

Indicator ( ) illuminate.

Press

CLOCK

Use the DAY, HOUR, and MINUTE buttons to set the correct time.

Press OK. Roomba will beep to indicate the time and date has been set.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Irobot Roomba 860 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Irobot Roomba 860

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info