Bedienungsanleitung Irox Aqua (Seite 30 von 32) (Deutsch, Englisch, Französisch, Italienisch)

578907

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

~P.30~

the first 24 hours of operation.

2. In periods of long stable weather conditions, it becomes difficult to make a reliable

forecast.

3. The weather forecast is solely calculated on the basis of barometric air pressure

changes.

4. The probability of a correct weather forecast is approximately 70% and is valid for

an area of approx. 20-30 km around the location of the weather station.

5. The forecast “Sunny” means at night “cloudless weather”. Fog is not indicated by the

weather station as this can occur with different weather conditions.

6. If you travel with the weather station, a reliable weather forecast will become

impossible due to changes in altitude and location. You’ll have to wait up to 24 hours

so that the weather station can calculate a new forecast based on the conditions at

the new location.

HOW TO CHECK THE BAROMETRIC PRESSURE

The current and historical barometric pressure is shown on the atmospheric pressure window.

For monitoring the Sea Level barometric pressure reading at certain altitude, the user needs to select

the local altitude (-100 to 2500 meter or -330 to 8250 foot) for the altitude setting. Our weather

station requires entry of elevation in meter and in foot separately.

1. To enter the altitude compensation setting mode, press and hold [HISTORY] button for 2 seconds

to switch from Barometric Pressure to Altitude adjust mode for 10 seconds and the meter icon

flashes.

2. During Altitude adjust mode, press [UNIT] button to toggle between meter and foot unit. Then

press [HISTORY] button to confirm.

3. Last altitude reading will flash, press [UNIT] button to increase the value by 10. Hold down the

button to have fast stepping. Press [HISTORY] button once to confirm and exit setting.

The atmospheric pressure can be displayed in mb/hPa, inHg. Press [UNIT] to select the pressure unit.

Our weather station is equipped with barometer reading for 24hr history. If you want to check the

pressure history for a particular hour during the past 24 hours, press [HISTORY] button, each press

on the button will go back by an hour.

Note: If the weather station was just installed with batteries and past data was not

yet measured, it will display “---”.

The recorded barometric changes for the past 24 hours are displayed in a bar chart below the

barometric pressure window.

SET BACKLIGHT COLOR

Press & hold [ MODE ] for 2 seconds to enter the backlight color setting and the barometric chart

displays a “C” pattern to prompt the user to set the color, the alternate backlight indicates the

backlight is set to auto mode and its color is changed according to the weather condition (see more

details in ‘BACKLIGHT COLOR CHANGE ACCORDING TO FORECAST WEATHER CONDITION’), press

[UNIT] button to select fix backlight color in the sequence, ‘WHITE’ -> ‘LIGHT BLUE’ -> ‘DARK BLUE’

and then cycle back to “auto mode”. Press [MODE] button to confirm the setting or auto exit after 10

second.

(ENG)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Irox Aqua Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info