•Also for temperature control of remote rooms, f.e.
children's room, wine-cellar
2.
Getting started
•Place the display unit and the transmitter on a
desk with a distance of approximately 1,5 meter.
Check that no other electronic devices are close.
•Take the display unit into operation according to
the manual of the display unit.
•Open the battery compartment of the transmitter
by pushing inwards the two latches at the bottom
and insert 2 x AA 1,5 V batteries, observing the
correct polarity.
•The LED indicator of the transmitter is blinking
and the transmitter is set to channel 1 by default.
•After the sensor is powered up, it will first
transmit the temperature and then the sensor will
start radio controlled time reception. During the
DCF time reception period (maximum 10
minutes), no weather data will be transmitted.
•After the reception of the radio controlled time
the DCF signal appears permanently on the
display of the weather station.
•Note: DO NOT PRESS ANY KEY during the first
10 minutes learning period or before radio
controlled time is displayed on the receiver. After
both outdoor values and radio controlled time are
displayed you can place your remote sensor
outdoors at the final destination. In case the clock
cannot detect the DCF-signal (example due to
disturbances, transmitting distance, etc.) the time
can be set manually. If the outdoor weather data
is not displayed or if any key is pressed before the
weather station receives the signal, or when
changing the transmitter batteries you will need
to follow the battery installation procedure again.
Please wait minimum 10 seconds before
reinserting the batteries!
Note for Radio Controlled Time DCF:
The time base for the radio controlled time is a
Caesium Atom Clock operated by the Physikalisch
Technische Bundesanstalt Braunschweig which has a
time deviation of less than one second in one million
years. The time is coded and transmitted from
Mainflingen near Frankfurt via frequency signal DCF-77
(77,5 kHz) and has a transmitting range of
approximately 1500 km. Your radio controlled clock
receives this signal and converts it to show the precise
time in summer or wintertime. The quality of the
reception. The quality of the reception depends greatly
on the geographic location. In normal cases, there
should be no receptions problems within a 1500 km
radius around Frankfurt.
Please take note at the following:
•The radio controlled time receiver is built inside
the thermo-sensor. It is recommended to keep
distance to any interfering sources and ferro-
concrete buildings.
•During night-time, the atmospheric disturbances
are usually less severe and reception is possible in
most cases. A single daily reception is adequate to
keep the accuracy deviation below 1 second.
3.
Positioning of the transmitter
•Choose a shady and dry position for the
transmitter. (Direct sunshine falsifies the
measurement and continuous humidity strains the
electronic components needlessly)
•Check the transmission of 433 MHz signal from
the transmitter to the display unit (transmission
range 30 m free field). Within ferro-concrete
rooms (basements, superstructures), the received
signal is naturally weakened.
•If necessary choose another position for
transmitter and/or display unit.
4.
Additional transmitters
•The sensor will automatically transmit
temperature to the display unit on channel 1 after
batteries are inserted.
•For having more than one external transmitter,
select a different channel (1 to 3) for every
transmitter by pressing the "CH" button on the
transmitter while the transmission indication LED
is flashing. Press twice for channel 2 and three
times for channel 3 right after the starting up of
the transmitter. The LED is flashing once for
channel 1, twice for channel 2 and three times for
channel 3.
•Press and hold the "CH" Button on the display unit
for 2 secs. To start initialization manually. The
channel number on the LCD of the display unit
flashes and the new transmitter will be received
automatically.
5.
Battery replacement Fig. 2
•Use alkaline batteries only. Observe correct
polarity. Low batteries should be changed soon to
avoid the damage resulting from a leaking battery.
Batteries contain harmful acids. Wear protective
glasses and gloves when handling with leaked
batteries!
Attention: Please do not dispose of old electronic
devices and used batteries in household waste. To
protect the environment, take them to your retail
store or to appropriate collection sites according to
national or local regulations.
6.
Specifications
Measuring range
Outdoor temperature: -20º C…+60º C
Operating temperature: -10º C…+50º C
Resolution temperature: 0,1º C
Transmission frequency: 433 MHz
Transmission range: max. 30 m
Batteries (included): 2 x 1,5 V AA
7.
Maintenance
•Do not expose the instrument to extreme
temperatures, vibrations or shock.
•Clean it with a soft damp cloth.
Do not use solvents
or scouring agents.
•Avoid placing the instruments near interference
sources/metal frames such as computer or TV sets.
•Please reset the unit and follow the battery
installation procedure if the unit does not work
properly. Change the batteries.
8.
Intended usage, exclusion of warranty,
safety information
•The product is not a toy. Keep it out of reacj of
children.
•The product is not to be used for medical purpose
or for public information, but is determined for
home use only.
•The specifications of this product may change
without prior notice.
•Improper use or unauthorized opening of housing
will mean the loss of warranty.
EU DECLARATION OF CONFORMITY
Herewith we declare, that this
wireless transmission device
does comply with the essential
requirements of R&TTE Directive
1999/5/EC
69
ETS69
Elements Fig. 1
D1: Transmission indication LED
D2: Wall mount hole
D3: Battery compartment holders
D4: "CH" Button
Brauchen Sie Hilfe? Stellen Sie Ihre Frage.
Missbrauch melden von Frage und/oder Antwort
Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.
Art des Missbrauchs:
Forenregeln
Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:
Lesen Sie zuerst die Anleitung;
Schauen Sie nach, ob die Frage bereits gestellt wurde;
Stellen Sie die Frage so deutlich wie nur einigermaßen möglich;
Erwähnen Sie was Sie bereits versucht haben um das Problem zu lösen;
Ist Ihr Problem von einem Besucher gelöst dann lassen Sie ihn / sie wissen in diesem Forum;
Falls Sie reagieren möchten, so verwenden Sie bitte das Antworten- Formular;
Da ihre Frage für alle Besucher sichtbar ist, sollten Sie lieber keine persönliche Daten erwähnen.
Neu registrieren
Registrieren auf E - Mails für Irox ETS69 wenn:
neue Frage gestellt werden
neue Handbücher vorhanden sind
Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.
Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.
Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.
Ihre Frage wurde zu diesem Forum hinzugefügt
Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.
