578936

Irox HBR425i Seite 19

19
Zoom out
Zoom in
Vorherige Seite
1/21
Nächste Seite
67 68
6665
4c) MAXIMUM AND MINIMUM
TEMPERATURES AND HUMIDITY
The maximum and minimum recorded indoor temperature,
humidity and outdoor temperatures will be automatically
stored in memory. To display them, Press [ MEM ] once
to display the maximum readings and again the minimum
readings. The respective indicators,
[ MAX ] or [ MIN ] will be displayed.
To clear the memory, hold down [ MEM ] for two seconds.
The maximum and minimum readings will be erased.
If you press [ MEM ] now, the maximum and minimum
readings will have the same values as the current ones until
different readings are recorded.
4. THERMOMETER
4a) HOW TO CHECK REMOTE AND
INDOOR TEMPERATURES
The wave display on the outdoors temperature indicates
the reception of the remote unit is in good order. If no
readings are received from the remote unit for more than
two minutes, blanks “ ” will be displayed until further
readings are successfully searched. Check the remote unit
is sound and secure. You can wait for a little while or
Hold [ ] for 2 seconds to enforce an immediate search.
If the temperature goes above or below than
the measuring range of the main unit or the remote unit
(stated in specification), the display will show “ ” &
“HHH” or “LLL” respectively. The unit can be set to
automatically scan and display readings from the remote
sensors, the display will show the readings from one
channel for about 4-seconds and then proceed to the next
channel display.
-To activate the remote-sensor scanning mode:
Press and the hold the button [CHANNEL] for 2 seconds.
-To deactivate the remote-sensor scanning mode:
Press and the hold the button [CHANNEL] for 2 seconds.
4b) HOW TO READ THE KINETIC
WAVE DISPLAY
The kinetic wave display shows the signal receiving
status of the main unit. There are three possible forms:
The unit is in searching mode.
Temperature readings are
securely registered.
No signals.
Arrow
indicator
Temperature
Humidity Trend
Steady FallingRising
4e) TEMPERATURE AND HUMIDITY TREND
The trend indicator shows the trend of temperatures and
humidity collected at that particular remote sight.
Three trends: rising, steady, and falling will be shown.
3b) BAROMETRIC PRESSURE TREND
The atmospheric pressure indicator, in the weather forecast
window, uses arrows to indicate if the atmospheric
pressure is increasing, remaining stable, or decreasing.
3. WEATHER FORECAST
3a) WEATHER FORECAST
The unit is capable of detecting atmospheric pressure
changes. Based on collected data, it can predict the weather
for the forthcoming 12 to 24 hours.
Arrow
indicator
Pressure
Trend
Steady FallingRising
NOTE:
1. It is not necessary and not possible to adjust the altitude
of the weather station. After the initial start-up of the
weather station, a first forecast will be made within the
first 24 hours of operation.
2. In periods of long stable weather conditions, it becomes
difficult to make a reliable forecast.
3. The weather forecast is solely calculated on the basis of
barometric air pressure changes.
4. The probability of a correct weather forecast is
approximately 70% and is valid for an area of approx.
20-30 km around the location of the weather station.
5. The forecast “Sunny” means at night “cloubless weather”.
Fogis not indicated by the weather station as this can
occur with different weather conditions.
6. If you travel with become impossible due to changes in
altitude and location. You'll have to wait up to 24 hour so
that the weather station can calculate a new forecast
based on the conditions at the new location.
Indicator
displays
on the unit
Temperature
Range
Humidity
Range
Shows that the
Current
Environment
COM
WET
DRY
No
Indicator
40%RH-
70%RH
OVER
70%RH
Below
40%RH
40%RH
to
70%RH
Ideal range for
both relative
humidity and
temperature
Contains excess
moisture
Contains
inadequate
moisture
No comment
20˚C to 25˚C
(68˚F to 77˚F)
-5˚C -+ 50˚C
(23˚F - 122˚F)
-5˚C -+ 50˚C
(23˚F - 122˚F)
Less than
20˚C (68˚F)
or More than
25˚C (77˚F)
4f) COMFORT LEVEL INDICATORS
The comfort level indicators COM, WET or DRY will tell you
if the current environment is comfortable, too wet or too dry.
The comfort indicators will appear on the display of the main
unit when the following conditions are satisfied:
˚C
Forecast
Symbols
Forecast
Symbols
Sunny Slightly Cloudy Cloudy
SnowyHeavy rainyLittle rainy
… 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Irox HBR425i wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info