578586

Irox HBR553 Anleitung

1
Zoom out
Zoom in
Vorherige Seite
1/3
Nächste Seite
KSPO:1023-11(OST)
IROX TE368NL&TS21 MANUAL 1(Eng)
SIZE:W100 x H100(mm)
BY Lai HZ 20/10/11
HBR553
Barometric Weather Station with
Radio Controlled Clock and
In/ Out Thermometer
1. Introduction
2. Operating elements
2.1 LCD (display) and keys / front view / rear view
2.2 Stand
2.3 Remote temperature sensor
3. Putting into operation
4. Operation
4.1 Weather forecast window
4.2 Temperature window
4.3 Clock window
4.3.1 Time function
4.3.2 Wake-up alarm function
5. Troubleshooting
6. Care instructions
7. Support
8. Technical data
1. INTRODUCTION
Thank you for selecting the HBR553 from IROX. In your hands, you hold a high-quality
weather station which we have equipped with additional functions that have above-
average design and functionality in a market comparison.
Please keep this manual handy as it contains practical instructions, technical specifications
and precautions.
In this package, you will find:
• One main unit (receiver)
• One separate table stand
• One single-channel remote sensor (transmitter)
• One user manual
FEATURES OF THE MAIN UNIT
Time
• Precise time and date set via radio controlled time signals (DCF 77) from the time
transmitter in Frankfurt
• 12 or 24 hour time format selectable
• Manual adjustment of time and date (ideal if no DCF77 reception)
• Calendar date with month and day in 7 languages English, German, French, Italian,
Spanish, Dutch and Swedish
• Separate weekday and single alarm with crescendo function
• Programmable per alert alarm in case of potential ice on the road
Weather
• Weather forecast for the next 12 to 24 hour in seven large icons: sunny, slightly cloudy,
cloudy, rainy, heavy rainy, snowy and heavy snowy.
• User-defined high/low temperature alarm
• Indoor/outdoor temperature in up to 3 remote locations (Channel 1 sensor
included, additional sensors required for Ch 2 and 3)
FEATURES OF THE REMOTE SENSOR
• Remote data transmission to the main unit via 433 MHz frequency
Page 3
Page 4
Page 4
Page 6
Page 7
Page 8
Page 10
Page 10
Page 11
Page 13
Page 13
Page 15
Page 17
Page 18
Page 19
Page 20
Table of contents
A. WEATHER window
B. TEMPERATURE window
C. CLOCK window
D.▼ (DOWN) button
• Select the other window (Clock or Temperature)
• Press and hold for 2 seconds to search for wireless signal from remote sensor.
• Decrease parameters in the setting mode.
E. ALARM button
• When clock window has been selected, press once to display the alarm time of weekday
alarm (W), single alarm (S) and pre-alarm (Pre-AL).
---> Hold for 2 seconds, set weekday, single or pre-alarm’s alarm time.
• When temperature window has been selected, press once to display the highest or lowest
temperature alarm’s value.
---> Hold for 2 seconds, set the highest or lowest temperature alarm’s value.
• When alarm (time or temprature) is on, press once to stop the alarm .
F. CHANNEL button
• Press to display the outdoor temperature readings of Channels 1, 2 and 3. (additional
remote sensors are required)
• Hold for 2 seconds, enter into the circulation mode and outdoor temperature readings of
Channels 1, 2 and 3 will be displayed automatically in every 5 seconds.
G. MODE button
• When clock window has been selected, press once to toggle between time with seconds
display or time with weekday display.
---> Press and hold for 2 seconds, set language of the day of the week, year digit, month
digit, date digit, hour format (12/ 24 hours), calendar format, hour digit and minute digit.
• When temperature window has been selected, press and hold for 2 seconds to toggle the
temperature unit between Celsius or Fahrenheit.
H.▲ (UP) button
• Select the other window (Clock or Temperature)
• Increase the parameters in setting mode
• Press and hold for 2 seconds to activate/ deactivate radio controlled time signal search
manually.
I. MEM (HISTORY) button
• When temperature window has been selected, press to recall the minimum or maximum
temperature readings of main and remote units.
• Press and hold for 2 seconds, collected memories will be cleared.
J. BATTERY COMPARTMENT
• Accomodate two (2) AAA batteries
2.2 STAND
K. TABLE STAND
• In addition you will find a separate table stand, giving the unit a special elegance when
positioned in a shelve or on a table
2.3 REMOTE TEMPERATURE SENSOR
A. BATTERY COMPARTMENT: Holds two AAA-size batteries
B. WALL-MOUNT RECESSED HOLE: Mount the sensor using the clip on the wall
3. PUTTING INTO OPERATION
The communication between the main unit (receiver) and the remote sensor (transmitter)
is wireless, thus simplifying the installation. The remote temperature sensor transmits data
to the main unit, with an operating range of up to 100 feet (30 meters) in opened area.
The remote temperature sensor can be placed indoors or outdoors, depending on the area
where the temperature is intended to be measured. If you intend to measure outdoor
conditions, place the remote sensor outdoors.
Start-up the transmitter-receiver communication:
• It is important to power-up the remote sensor BEFORE powering-up the main unit.
Immediately after batteries are installed, the remote sensor will start transmitting a
temperature data to the main unit.
• It is strongly recommended to power up and test communication between the remote
sensor and the main unit BEFORE permanently mounting the sensor outside.
• During initial set up, place the remote sensor within a range of 1m to the main unit in the
same room, both receiver and transmitter far from any other electric product.
• After reception is established (remote readings will appear on the main unit’s display),
position the remote sensor and the main unit within the maximum transmission range of
up to 30 meters (100 feet).
NOTE:
• Avoid pressing any button on the main unit before the remote readings are displayed.
• Transmission or reception range may be affected by trees, metal structures, electronic
appliances, surrounding building materials and how the main unit and transmitter are
positioned.
2. OPERATING ELEMENTS
2.1 LCD (DISPLAY) AND KEYS / FRONT VIEW / REAR VIEW
All functions are depicted on the liquid crystal display (LCD) in 3 windows.
A
B
H
D
G
I
E
F
J
C
2
43
65
87
1

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Irox HBR553 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Irox HBR553

Irox HBR553 Bedienungsanleitung - Deutsch - 3 seiten

Irox HBR553 Bedienungsanleitung - Französisch - 3 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info