Bedienungsanleitung Irox ORBIT 2 (Seite 1 von 2) (Englisch)

578887

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

ORBIT 2 - Radio controlled clock with Silent Mode

HOW TO OPERATE

1- To start the clock

Insert the battery into the battery compartment in the indicated polarity. The clock will start to receive the

time signal DCF77 automatically.

2- Time signal reception mode

a) Automatic reception mode

- The time reception will start after inserting the battery

- Twice a day the clock will synchronize the time

b) Manual mode

- A time signal reception can be started by pressing the WAVE button for 3 seconds.

After starting a full reception, the seconds, minutes and hours hands will move to the 12 o'clock position and

remain there as long as the reception takes place. A full reception may take 3-10 minutes.

Upon completion of a successful reception, the clock will move the hands to the exact time and continue to

operate as a clock. Should there be no good reception, the clock will start working from the 12 o'clock

position. In this case, you may adjust the time manually.

3- Manual time setting mode

Press and hold the SET button. Now you have entered the manual time setting mode and the minutes hand

will keep moving forward for as long as you press the SET button. The clock will exit form the time setting

mode if you do not press the SET key for more than 6 seconds and continue to operate as a clock.

4- Reset

On rare occasions the clock may not respond when pressing buttons or well functioning. In this case, you

need to reset the clock by pressing the RESET button at the backside of the clock. By doing this, the clock

will start-up newly in the same way as described above after inserting a new battery.

5- To set alarm, light, Electronic light and snooze features

Turn the knob on the backside counter-clockwise to set the alarm hand at the desired time.

Then, set the alarm ON/OFF switch on ON position.

When the alarm time is reached, the alarm will sound 2 minutes with increasing intensity. To interrupt the

alarm, please read below in section "7-Snooze".

6- Silent mode (to avoid any noise from the clock movement)

The silent mode is enabled by setting the alarm ON/OFF switch on the rear of the clock to the ''ON'' position.

The seconds hand will then move to the 12 o'clock position and remain there until the switch is moved to the

OFF position again. Upon activating/deactivating the silent mode, you may have to wait up to one minute to

see the seconds hand stop or move again.

7- Snooze

a) Manual

During the 2 minute alarm sound, you may press Snooze (button at the backside above the Alarm ON/OFF

switch). The alarm will then be interrupted for 4-5 minutes and then sound again. You may repeat such

Snooze cycles within 40 minutes of the initial alarm time. After this, the clock will stop and, if the alarm is left

"ON", sound again at the set time 12 hours later.

b) Automatic

If no key is pressed during the 2 minutes alarm sound, then the alarm will be repeated after 5 minutes

automatically ( there are totally two 2 such automatic repetitions if no key is pressed). After this, the clock will

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Irox ORBIT 2 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Irox ORBIT 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info