Bedienungsanleitung Irox PE-109 (Seite 5 von 8) (Englisch)

578900

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

4. Set a function (MODE)

Press the ‘MODE’ key repeatedly until you have reached the desired function. You have a selection of the

following functions (the short text shown here in brackets appears at the top of the display):

The time always appears at the bottom of the display – apart from in the 7-day data memory mode!

- Step counter (STEP)

- Distance covered (KM or MILE)

- Calories burned (KCAL)

- Time active – measurement of amount of time walked in minutes (MIN)

- 7-day data memory (STEP) – at the bottom, instead of the time, the display shows -1 DAYS

RECORD

- Totalizer for all measurements (TOTAL STEP)

‘TOTAL STEP’ is followed by the first function ‘STEP’.

As soon as you have reached the desired function, you can operate the device as described below.

Caution: If you do not press any key for more than 3 minutes or if the device is not moved, the device

automatically switches to a save-battery mode, i.e. the display is switched off. All functions continue to run in

the background. To reactivate the display, either move the device or press one of the keys.

4.1 The function STEP (step counter)

Allows you to set the time and your personal details

You can also use the PE-109 as a quartz watch. You can set the time and your personal details. To use the

additional possibilities of the PE109, you have to enter your personal details. These data are then used to

calculate the following information:

- Distance

- Calories burned

- Graphic display of the steps taken compared with the target for the day (in 10% steps)

Please note:

- The correct setting is important in order to be able to use the memory function correctly. At midnight, your

step data for the day will automatically be stored in the memory and counting for the new day then starts

from zero again.

- Some information (distance, kcal, target) requires the input of your personal details.

Setting

Press and hold the SET key in the STEP mode (approx. 4 seconds) until the ’24-hour’ display starts to flash

and SETUP is displayed in small letters to the right. You can change the setting with the MODE and RESET

keys. With the SET key, you move to the next setting.

Setting sequence (the element to be set flashes):

24/12-hour time display ---> hour setting ----> minute setting ---> unit of step length cm/inch (used for the

bodyweight kg or pounds) ---> step length in the set unit (30-213cm / 12-84 inch)---> your body weight (20-

220kg / 50-500LB)) ---> target number of steps per day (100-99000 steps can be set in increments of 100 or

1000)

After the last setting in the sequence, namely the target number of steps per day, the setting is completed by

pressing on the SET key and you go back to the time display.

Caution: In the setting mode, if no key is pressed for more than 10 seconds, the change that has been made

is accepted and the setting mode is exited automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Irox PE-109 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Irox PE-109

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info